Remington 100089-06 Owner's Manual download pdf (Page 26)

CLEANING AND

MA' a T E acAnNnCu E

Normal Guide Bar Maintenance

1. Remove guide bar from chain saw.

2. Remove sawdust from guide bar groove periodically. Use putty knife or wire.

3. Clean oil slots after each day of use.

4. Remove burrs from sides of guide bar. Use flat file to make side edges square.

Burr

Flat File

Cleaning Groove _ __ /

WRh Putty Knife

Oil Slot

Figure 19 - Guide Bar Maintenance

Guide

Bar

Replace guide bar when

• bar is bent or cracked

• inside groove of bar is badly worn

Note: When replacing guide bar, see Replacement Parts and Accessories, page 28

for pmper bar.

SHARPENING'YOUR SAWCHAIN

(Non-Fast Sharp Model)

WARNING

Unplug chain saw from power source before servicing. Severe

injury or death could occur from electrical shock or body contact

with moving chain.

WARNING

Cutting edges on chain are sharp. Use protective gloves when

handling chain.

O97O17

Keep chain sharp. Your saw will cut faster and more safely. A dull chain will cause

undue sprocket, guide bar, chain, and motor wear. If you must force chain into wood

and cutting creates onJy sawdust with few large chips, chain is dull.

Items Needed to Sharpen Chain

Purchase these items from your local dealer, hardware store, or chain saw supplies

outlet.

5/32" round file • Depth gauge tool

File guide • Vise

• Medium sized fiat file Continued

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Remington 100089-06 Owner's Manual Page 26