Remington 100089-06 Owner's Manual download pdf (Page 4)

UNPACKING

1. Remove allitems from carton.

2. Chock allitems for any aldpp'mg dam-

age, If you find any damage or ff any

parts are missing, promptly inform

deelar where you bought the Pole Saw.

ASSEMBLY

The plastic hardware bag for the Pole Saw

should include the following:

CHAIN SAW HARDWARE

(2) Guidebar bolts

• (2) Guidebar outs

• (1) Phillips sdftapping screw

• (1) Saw chain

• (I) Guide bar

• (1) Hand g_rd

• (1) Scabbard

POLE SAW HARDWARE

• (1) Handlebracket

• (4) #I0 x 24 Phlnlpsscrews

• (4) #101ockwashers

ASSEMBLY OF CHAIN SAW

Asserable the chain saw before assembling

the pole. Refer to chain saw manual for

assembly iustructions.

,_ CAUTION: Do not place chain

on saw backwards. If chain is

backwards, saw will vibrate badly

and will not cut.

F

Make sure cutting edges of chain are facing

in the right direction. Position chain so cut-

flog edges on top of guide barface gradebar

nose (see Figure 2).

Towards Cutting

Guide Bar. ",Edge

Nose

Edge

Chain

F?gum2- Chain Position

OWNER'S MANUA

SAW CHAIN TENSION

ADJUSTMENT

WARNING: Maintaln proper

chain tension. A loose chain will

increase the risk of kick back. A

loose chain may jump out of

guide bar groove. This may in-

jure operator and damage chain.

A loose chain will cause chain,

guide bar and sprocket to wear

rapidly.

1. To adjust chain tension, make sure

guide bar nuts are only finger fight.

Also make sure adjusting block is in

oval adjust_g hole on guide bar.

2. Turn adjusting screw cIockwlsu until

all slack is out of chain. Note: Them

should be no gap between side links of

chain and bottom of guide bar.

3. Wearing protectivegloves,move chain

aroundguidebar. Chain should move

freely. If chain does not move freely,

loosen chainby turningadjusting screw

counterclockwise,

.

After chain tension is correct, tighten

guide bar nuts firmly. If not, guide bar

will move and loosen chain tension.

This will increase the risk of kickback.

This can also damage saw.

ASSEMBLY OF POLE SAW _'/:

• l. Slip handle bracket over chain saw

handle fromthe fightside (see Hga_ 5).

Note: The trigger must be depressed

before the bracket will go onto the

handle,

• Push the lockout buttonanddepresstbe

trigger, While holding the trigger in,

place the trigger supportportionof the

bracket under the triggerand slide the

bracket onto the chain saw handle.The

bracket will keep thetriggerin the "on"

posifiou,

2_ Align holes in pole bracket with holes

in handle bracket. Install Phillips head

screws with lcokwasb_ throughpole

bracketfromleft side and threadinto

theweld nutson thehandlebracket.

Tightenscrewssecurelybyhand.

3. Plugthesawpowercordintoreceptacle

cordatendofinnerpole.

Bracket

Trigger

Support

Figure 5 - Bracket with Trigger Support

Figure 3 - Turning Adjusting Screw

incorrectTension

Figure 4 - Saw ChainAdjustment

Figure 6- Assembly ofPoleSawBrackef

to,_ 5

1 2 3 4 5 6 7 8 9 ... 33 34

Comments to this Manuals

No comments