Remington 100089-06 Owner's Manual download pdf (Page 31)

TROUBLE-

SHOOTING

,/k WARNING

Unplug chain saw from power source before servicing. Severe

injury or death could occur from electrical shock or body contact

with moving chain.

OBSERVED POSSIBLE

FAULT CAUSE REMEDY

Saw runs, but does Chain asserabled backwards See Assembly, page 8

_ot cut. on guide bar

Saw does not cut Chain is dull See Sharpening your

unless heavily Saw Chain, page 2 I

forced. Cutting (non-Fast Sharp model) or

produces only page 24 (Fast Sharp

sawdust with few model)

large chips.

Saw runs Slow. Low power supply voltage Extension cord wire size too

Saw stalls easily, small. See ExterLfion

Cords, page 12

Motor of saw does Switch lockout not pressed in Press in switch lockout

not run whenyou m releasetrigger before squeezing trigger

squeeze_gger. Extension cord connections

loose

Open line fuse or circuit

breaker

Bad motor brushes

Open wiring circuit on saw

Check cord connections

Check line fuse or circuit

breaker

See authorized service center

(see page 29)

See authorized service center

(see page29)

Motor of sawruns,

butchaindoesnot

move.

Gear train failure See authorized service center

(see page 29)

Chain does not get

oil.

Clogged oil slot in guide bar

Oil is too thick

Remove guide bar and clean

oil slot

Use correct weight of oil.

See Filling Oil Tank,

page 11

Chain comes off Chain is loose Tighten chain. See Saw

guide bar. Chain Ter_ion

Adju_tmem, page 10

Guide bar and chain not Se_ Assembly, page g

assembled right

Saw smokes. Saw damaged. Do not use saw. See authorized service center

(see page 29)

Saw leaks oil. Oil cap is not secure. Tighten oil cap.

Note: Empty oil tank

when not in use.

1 2 ... 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Remington 100089-06 Owner's Manual Page 31

Comments to this Manuals

Related products and manuals for Power chainsaws Remington 100089-06