Remington 100089-06 Owner's Manual download pdf (Page 13)

UNPACKING

ASSEMBLY

1. Remove all items from carton.

2. Check all items for any shipping damage. If you find any damage or if any parts

are missing, promptly inform dealer where you bought chain saw.

. J

Note: Some models a_mpm assembled. Assembly is not needed on these models.

See Saw Ct_in Tension Adjusunent, page 10.

WARNING I

Cutting edges on chain are sharp. Use protective gloves when

handling chain.

IMPORTANT

Do not clamp chain saw in vise during assembly.

The plastic I_ardware bag should include:

• two guide bar bolts

• two guide bar nuts

• one Phillips-head tapping screw

• automatic chain sharpener (Fast Sharp models only)

1. Lay chain out fiat.

2. Install front hand guard onto saw body. Dothis by pressing two mounting

stand-outs on hand guard into hex-shaped holes in saw body (see Figure 3).

3 Insert tapping screw through hand guard and into saw handle. Tighten screw

firmly.

4. Turn adjusting screw counterclockwise (see Figure 4). Continue to turn adjust-

ing screw until adjusting block is to rear of adjusting plate.

5. Install guide bar onto saw body. Place rear of guide bar between adjusting plate

and sprocket support. IMPORTANT: Make sure to insert adjusting block into

oval adjusting hole on guide bar.

6. Line up holes on sprocket support with center slot on geide bar and holes in saw

body.

7. Insert guide bar bolts through front hand guard, saw body, center slot of guide

bar, and sprocket support. Attach guide bar nuts to guide bar bolts.

IMPOFITANT: Tighten guide bar nuts finger tight only. Make sure adjusting

block is in ova! adjusting hole on guide bar.

8. Place chain around drive sprocket, then along top groove of guide bar and

around guide bar nose. Note: Make sure cutting edges of chain are facing the

right direction. Position chain so cutting edges on top of guide bar face guide

bar nose (see Figure 3).

. CAUTION

Do not place chain on saw backwards. If chain is backwards, saw

will vibrate badly and will not cut.

9. Affjustsawchffmtandon.FollowstepsunderSawCJlainTensionAd]usLme-nf,

page 10.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Comments to this Manuals

No comments

Remington 100089-06 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Power chainsaws Remington 100089-06