Remington 106821A Owner's Manual download pdf (Page 14)

111219

www.desatech.com

CAUTION: Do not place chain on saw

backwards. If chain is backwards, saw

will vibrate badly and will not cut.

1. Before adjusting chain, make sure guide bar nuts

are only ﬁnger tight (see Figure 4). Also make

sure adjusting block is in oval adjusting hole on

guide bar.

2. Turn adjusting screw clockwise until all slack

is out of chain.

Note: There should be no gap

between side links of chain and bottom of guide

bar.

3. Wearing protective gloves, move chain around

guide bar. Chain should move freely. If chain

does not move freely, loosen chain by turning

adjusting screw counterclockwise.

4. After chain tension is correct, tighten guide

bar nuts ﬁrmly. If not, guide bar will move and

loosen chain tension. This will increase the risk

of kickback. This can also damage saw.

Note:

A new chain will stretch. Check new chain after

ﬁrst few minutes of operation. Allow chain to

cool down. Readjust chain tension.

SAW CHAIN TENSION ADJUSTMENT

WARNING: Maintain proper chain ten-

sion always. A loose chain will increase

the risk of kickback. A loose chain may

jump out of guide bar groove. This may

injure operator and damage chain. A

loose chain will cause chain, guide bar,

and sprocket to wear rapidly.

ASSEMBLY

The plastic hardware bag for the Pole Saw should

include the following:

CHAIN SAW HARDWARE

• (1) Scabbard

POLE SAW HARDWARE

• (1) Handle Bracket

• (1) Knob

• (1) Lock Washer

ASSEMBLY OF CHAIN SAW

Assemble the chain saw before assembling the pole.

Refer to chain saw manual for assembly instructions.

ASSEMBLY OF POLE SAW

Push in and hold

trigger lockout button.

Squeeze and hold

trigger.

Step ❶ – Squeeze Trigger

Step

❷ – Insert Pole Bracket into Saw

Insert pole

bracket into

saw.

Note: Pole

Bracket holds

trigger in “ON”

position.

Oiler Control System for oiling guide bar and chain.

Outer Pole Retains the moveable inner pole.

Saw Chain (Chain) Loop of chain having cutting

teeth for cutting wood. The motor drives chain. The

guide bar supports chain.

Sprocket Toothed wheel that drives chain.

Switch Device that completes or interrupts electrical

circuit to motor of saw.

Switch Lockout Device that reduces accidental

starting of saw.

Trigger Device that turns saw on and off. Squeezing

trigger turns saw on. Releasing trigger turns saw off.

Trimming (Pruning) Process of cutting limb(s) from

a living tree.

Undercut An upward cut from underside of log or

limb. This is done while in normal cutting position

and cutting with top of guide bar.

POLE SAW NAMES AND

TERMS

Continued

Make sure cutting edges of chain are facing in the

right direction. Position chain so cutting edges on top

of guide bar face guide bar nose (see Figure 2).

Continue to hold trigger

while completing step 2B.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments

Remington 106821A Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Power chainsaws Remington 106821A