Remington S8102 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
ENGLISH
4
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their safety should give explicit
instructions or supervise the use of the appliance.
Do not use any attachments with this styler, other than those supplied by Remington
®
.
Avoid allowing any part of the hot plates to contact the face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
This product is not intended for commercial or salon use.
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged,
discontinue use immediately and return the appliance to your nearest authorised
Remington
®
service dealer for repair or replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other items(s),
caused by misuse, abuse or non-compliance with these instructions.
080725 REM IFU S8102-8203 INT_22L.indd GB_4 03.11.2008 17:30:10 Uhr
WIRING INSTRUCTIONS UK Plugs Only
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult
a qualified electrician.
The wires in the mains lead are coloured in accordance with following code:
BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked
‘N’ or coloured BLACK. The wire which is coloured BROWN must be connected to the
terminal which is marked ‘L’ or coloured RED. Never connect either of the wires to the big
EARTH terminal marked ‘E’ or coloured GREEN or GREEN AND YELLOW.
E
L
N
NEW WIRING
COLOUR CODE
BLUE
TO NEUTRAL
BROWN
TO LIVE
ENGLISH
5
GBDNLFEIDKSFINPSKCZPL
HUN
RUTRROGRSLAE
HR/
SRB
GB
SERVICE AND WARRANTY
This product has been checked and is free of defects. We warrant this product against any
defects that are due to faulty material or workmanship for the warranty period from the
original date of consumer purchase. If the product should become defective within the
warranty period, we will repair any such defect or elect to replace the product or any part
of it without charge provided there is proof of purchase.
This does not mean an extension of the warranty period.
In the case of a warranty simply call the Remington
®
Service Center in your region.
This warranty is offered over and above your normal statutory rights.
The warranty shall apply in all countries in which our product was sold via an authorised
dealer.
This warranty does not include damage to the product by accident or misuse, abuse,
alteration to the product or use inconsistent with the technical and/or safety instructions
required. This warranty shall not apply if the product has been dismantled or repaired by a
person not authorised by us.
For further information on recycling see www.remington-europe.com
080725 REM IFU S8102-8203 INT_22L.indd GB_5 03.11.2008 17:30:10 Uhr
PROTECT THE ENVIRONMENT
For further information on recycling see www.remington-europe.com
Do not dispose of the product in household waste at the end of its life. Disposal can take place at
the Remington® Service Centre or appropriate collection sites.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 111 112

Comments to this Manuals

No comments