Remington R-1000 Owner's Manual download pdf (Page 15)

To Disassemble

(Model 11-87)

WARNING:

Check the chamber and the magazine to make sure there are

no shells in the firearm.

1. Point the firearm in a safe direction.

2. Engage the safety mechanism.

RED BAND WILL NOT SHOW.

3. Pull the operating handle fully rearward until the bolt is held open

by the carrier latch.

4. Unscrew and remove the magazine cap.

5. Slide the fore-end forward and remove it from the magazine tube.

NOTE:

A gas cylinder collar is used on 12-ga. models only.

11-87 12-ga. Super Magnum does not use a gas cylinder collar

6. Remove the gas cylinder collar. See Picture 12 on page 11.

7. Hold the barrel in front of the gas cylinder. Pull the barrel

from the receiver.

FOR 11-87 12-GA. SUPER MAGNUM ONLY:

Slide the barrel seal, barrel seal activator (when using 2

⁄4"

shells), and piston/piston seal assembly from the magazine

tube. See Picture 23a.

IMPORTANT:

A BARREL SEAL ACTIVATOR IS USED ON THE

MODEL 11-87 SUPER MAGNUM WHEN USING 2

⁄4" LOADS.

REMOVAL OF THE BARREL SEAL ACTIVATOR IS RECOM-

MENDED WHEN USING 3" OR 3

⁄2" LOADS.

FOR 11-87 12-GA. (

⁄4" - 3")

ONLY.

Slide the barrel seal and pis-

ton/piston seal assembly from the magazine tube. See Picture 23b.

FOR 11-87 20-GA. ONLY.

Slide the barrel seal, barrel seal activator,

piston and piston seal from the magazine tube. See Picture 24.

9. Hold the operating handle and close the action.

10. Pull the operating handle from the bolt. See Picture 21.

11. Push the carrier release and push upward on the carrier.

12. Reach in the bottom of the receiver. Press and hold the feed latch.

See Picture 22.

13. Pull the action bar assembly from the receiver and the magazine

tube. Release the feed latch.

14. Lift the breech bolt assembly from the rear of the action bar assembly.

15. Replace the magazine cap.

16. Tap out the front and rear trigger plate pins. See Picture 25.

17. Lift the rear of the trigger plate assembly, slide rearward and

remove it from the receiver.

WARNING: DO NOT

allow the hammer to snap forward when the

trigger plate assembly is removed. This can best be assured by keep-

ing the safety mechanism engaged at all times.

RED BAND WILL

NOT SHOW.

PICTURE 23b

PICTURE 24

PICTURE 23a

PICTURE 25

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments

Remington R-1000 Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Men's shavers Remington R-1000