Remington R-1000 Owner's Manual download pdf (Page 10)

III. TO CLEAN THE BARREL AND CHOKE TUBE FOLLOW THE INSTRUCTIONS SHOWN ON PAGE 16.

BEFORE LOADING THE FIREARM:

Make sure the inside of the barrel is free of dirt or other objects.

To Change the Choke Tube

WARNING: UNLOAD

the firearm before changing choke tubes. Leave the action

OPEN

and the chamber and

magazine

EMPTY.

1. Point the firearm in a safe direction.

2. Engage the safety mechanism. Make sure the

RED BAND IS NOT SHOWING.

3. Place the choke tube wrench into the choke tube.

4. Turn the wrench counterclockwise and remove the choke tube.

5. Select the desired choke tube and insert the tube into the barrel.

6. Tighten the choke tube snugly but

DO NOT OVER-TIGHTEN.

7. With the bolt open and the chamber and magazine empty, check the choke tube occasionally to make sure

it has not loosened.

NOTE:

NEVER fire the firearm without

the choke tube installed.

To Assemble (

Model 1100™)

The Model 1100™ is shipped with the

barrel assembly removed. See Picture 9

for location of parts.

WARNING:

MODEL 11-87™ BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 1100 FIREARMS.

MODEL 1100 BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 11-87 FIREARMS.

NOTE:

The barrel and chamber should be cleaned before assembling the firearm. Clean the barrel following the

instructions on page 16.

1. Point the firearm in a safe direction.

2. Engage the safety mechanism.

RED BAND WILL NOT SHOW

3. Pull the operating handle fully rearward to open the action.

4. Unscrew and remove the magazine cap.

5. Slide the fore-end forward and remove it from the magazine tube.

6. Remove the cardboard packing ring from the magazine tube.

7. Hold the barrel in front of the gas cylinder. See Picture 10.

8. Place the gas cylinder over the end of the magazine tube.

9. Align the long slot on the rear of the barrel with the stud

projecting from the inside of the receiver. See Picture 11.

NOTE:

28 & .410 gauge barrels have short barrel extensions.

Align the ejector slot in the end of the barrel with

the ejector located inside the receiver. Do not jam the

barrel against the ejector.

10. Seat the barrel firmly into the receiver.

11. Slide the fore-end over the magazine tube.

12. Replace and tighten the magazine cap.

PICTURE 10

PICTURE 11

Gas Cylinder

Collar

Remove Wire Tie

PICTURE 9

FULLY ASSEMBLED MODEL 1100

(Model 1100 LT-20 Shown)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Comments to this Manuals

No comments

Remington R-1000 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Men's shavers Remington R-1000