Remington R-1000 Owner's Manual download pdf (Page 9)

The Operating Handle

The operating handle is used to pull the bolt rearward to open the action.

See Picture 7.

WARNING:

When the operating handle is forward as shown in Picture 7,

the bolt is closed and the firearm can be fired.

The Carrier Release

1. Point the firearm in a safe direction.

2. Engage the safety mechanism.

RED BAND WILL NOT SHOW.

CAUTION:

Keep your fingers away from the ejection port and operating handle.

4. Push the carrier release to close the action. See Picture 8.

The Trigger

Pulling the trigger fires the firearm.

The weight of the trigger pull is preset at the factory.

All adjustments to the trigger and trigger plate assembly must be made by the factory or a

REMINGTON

AUTHORIZED SERVICE CENTER.

WARNING: NEVER

put your finger on the trigger unless you are going to fire the firearm.

The Barrel

The inside of the barrel must be clean and free of obstructions.

I. TO CHECK THE INSIDE OF THE BARREL:

WARNING:

LOOK INTO THE EJECTION PORT. CHECK THE CHAMBER AND MAGAZINE TO MAKE SURE THERE ARE NO

SHELLS IN THE FIREARM.

1. Point the firearm in a safe direction.

2. Engage the safety mechanism. Make sure the

RED BAND IS NOT SHOWING.

3. Pull the operating handle fully rearward until the bolt is locked open.

4. Insert a cleaning rod into the muzzle. Push the rod completely through the barrel until rod can be seen in

the ejection port.

WARNING:

MODEL 11-87™ BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 1100™ FIREARMS.

MODEL 1100 BARRELS CAN NOT BE USED AS REPLACEMENT BARRELS ON MODEL 11-87 FIREARMS.

MODEL 11-87 SUPER MAGNUM™ BARREL REPLACEMENT:

ONLY MODEL 11-87 12-GAUGE BARRELS HAVING 3

⁄2" CHAMBERS CAN BE USED ON MODEL 11-87 SUPER

MAGNUM RECEIVERS.

NEVER ATTEMPT TO ASSEMBLE ANY MODEL 11-87 12-GAUGE BARREL WITH A CHAMBER LENGTH SHORTER

THAN 3

⁄2" TO A RECEIVER MARKED MODEL 11-87 SUPER MAGNUM.

WARNING FOR MODEL 11-87 LIGHT CONTOUR 12-GAUGE BARRELS

WARNING: DO NOT

overbore or polish the barrel of your Model 11-87 LIGHT CONTOUR Barrel shotgun. The

weight reduction in this barrel is achieved by reducing the outside profile to the minimum SAFE dimension. Any

additional reduction in the barrel wall thickness may make the barrel unsafe to fire, and further use could result

in serious personal injury.

II. TO REMOVE OBJECT FROM INSIDE THE BARREL:

WARNING: NEVER

try to remove an object from the barrel by loading another shell and firing. This may cause

the barrel to burst or a cartridge case to rupture and cause serious personal injury.

1. Remove the barrel following instructions shown on pages 14 and 15.

2. Use the correct cleaning rod.

3. Insert cleaning rod into the muzzle and lightly tap rod to free object(s).

4. If an object cannot be easily pushed out of the barrel with a cleaning rod, return the firearm to the factory

or a REMINGTON AUTHORIZED SERVICE CENTER.

PICTURE 7

PICTURE 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comments to this Manuals

No comments

Remington R-1000 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Men's shavers Remington R-1000