Remington R-1000 Owner's Manual download pdf (Page 17)

THE TRIGGER PLATE ASSEMBLY:

NOTE:

Clean as a unit with Rem™ Oil only. See

NOTE

on next page

under LUBRICATION.

Spray the trigger plate assembly with Rem™ Oil as shown. See Picture 28.

Let stand for 15 minutes. Spray again to wash off components. Shake off

excess lubricant.

WARNING:

Excessive use of a non-recommended lubricant could cause

serious function problems possibly leading to accidental firing.

THE RECEIVER ASSEMBLY:

1. Brush the inside of the receiver with cleaning solvent and wipe dry.

2. Clean the outside surface of the magazine tube with cleaning solvent, then wipe dry with a clean cloth.

How to Reassemble

Check the inside of the receiver to make sure the link is in

position. See Picture 29.

TRIGGER PLATE ASSEMBLY:

1. Check to make sure that the end of the disconnector is below

the end of the left connector. See Picture 30.

2. Carefully insert the trigger plate assembly (carrier first) into the receiver.

3. Position to align holes and tap in front and rear trigger plate pins.

4. Remove the magazine cap.

5. Slide the action bar sleeve over the magazine tube.

6. Place the breech bolt assembly on the block at the rear of the

action bar assembly.

7. Slide the action bar assembly into the receiver until stopped

by the feed latch.

8. Push the carrier release and push upward on the carrier.

9. Reach into the bottom of the receiver. Press and hold the feed latch.

10. Slide the action bar assembly into the receiver and release the feed latch.

11. Push the operating handle into the breech bolt.

12.

FOR MODEL 11-87™ SUPER MAGNUM™ ONLY:

Slide

the piston/piston seal assembly, barrel seal activator (for

use with 2

⁄4" shells) and barrel seal over the magazine tube.

See Picture 31 for the correct position.

IMPORTANT:

A BARREL SEAL ACTIVATOR IS USED ON THE

MODEL 11-87 SUPER MAGNUM WHEN USING 2

⁄4" LOADS.

REMOVAL OF THE BARREL SEAL ACTIVATOR IS RECOM-

MENDED WHEN USING 3" OR 3

⁄2" LOADS.

FOR MODEL 1100™/11-87 12-GA. ONLY:

Slide the

piston/piston seal assembly and barrel seal over the

magazine tube. See Picture 32.

FOR MODEL 11-87 20-GA. ONLY:

Slide the piston seal,

piston, barrel seal activator and barrel seal over the

magazine tube. See Picture 33a on page 18.

FOR MODEL 1100 20, 28 AND .410 GA. ONLY:

Slide

the piston seal, piston and barrel seal over the magazine

tube. See Picture 33b on page 18 for the correct position.

PICTURE 28

PICTURE 32

PICTURE 29

PICTURE 30

PICTURE 31

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Comments to this Manuals

No comments

Remington R-1000 Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Men's shavers Remington R-1000