Remington i-Light IpL5000 Troubleshooting Guide download pdf (Page 17)

Troubleshooting / Storage / Maintenance

i-Light Device Maintenance

CAUTION:

Before performing maintenance on your i-Light device, ensure that the power

switch is OFF and the power cord is disconnected from the base unit.

Replacing the bulb

Press the nose cone release buttons and gently pull to remove the nose cone.

2. Gently pull out the old bulb cartridge.

3. Replace with a new bulb cartridge. Replacement model: SP-IPL

CAUTION:

When replacing the bulb cartridge, do not touch the flash bulbs directly as

this leaves oils and residue. Doing so could reduce the effectiveness of

the bulbs or cause them to crack during treatment.

Replace the nose cone, making sure it snaps into place.

Storage

■ Switch off the unit, unplug it and let it cool down for 10 minutes before storage.

■ Store the unit in a dry place at a temperature between 15º C and 35º C.

Troubleshooting

Always read these instructions fully before using i-Light.

Refer to this troubleshooting guide if you experience any problems with i-Light,

as this section addresses the most common problems you could encounter with

i-Light.

If you have followed the instructions in this section and continue to experience

problems, please contact the Remington

Service Center for further assistance.

I turn the power switch ON, but the unit is not working.

■ Make sure the unit is plugged into a working electrical outlet.

■ Try switching to a different outlet.

The unit appears to have cracks or is broken.

■ Do not use if the unit is damaged. If you have concerns about using the unit,

discontinue use and contact the Remington

Service Center for further assistance.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

No comments

Remington i-Light IpL5000 Troubleshooting Guide Page 17