Remington i-Light IpL5000 Troubleshooting Guide download pdf (Page 16)

Cleaning

Your Device

■ Do not depilate (waxing, plucking, threading or creams) during the treatment

– shaving is acceptable as long as you avoid shaving 24 hours after each

treatment.

■ Do not use bleaching creams or perfumed products for 24 hours after

treatment.

■ Do not scratch or pick at the treated area.

Cleaning Your i-Light Device

CAUTION: Before cleaning your i-Light device, make sure that the power switch is OFF and the

power cord is disconnected from the base unit.

■ Regular cleaning helps to ensure optimal results and a long life for the i-Light

device. The exterior surface of the base unit and hand piece may be wiped

clean with a slightly damp cloth.

■ To clean the Flash Window, use only the lint-free cloth included with your

i-Light device. Take care not to scratch or chip the Flash Window. Scratches

and chips can reduce the effectiveness of the unit.

■ For stubborn stains, use a dampened cotton swab to apply a small amount

of water to the Flash Window and clean with the lint-free cloth provided.

■ Use a small hand-held vacuum to remove dust and debris from the hand

piece vents.

WARNING: If the Flash Window is cracked or broken, the unit must not be used.

Never scratch the filter glass or the metallic surface inside the Nose

Cone.

CAUTION: The i-Light is a high voltage device. Never immerse in water. Never clean

the unit or any of its parts under the tap or in the dishwasher.

Do not use petroleum-based or flammable cleaning agents because of

the risk of fire. Never use scouring pads, abrasive cleaning agents or

aggressive liquids such as oil or acetone to clean the unit.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

No comments

Remington i-Light IpL5000 Troubleshooting Guide Page 16