Remington i-Light IpL5000 Troubleshooting Guide Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
GB
17
Frequently Asked Questions
I have switched the unit ON, but I cannot increase or decrease the light intensity.
Try resetting the unit by turning it off and waiting several seconds before turning it
back on.
The Bulb Status Indicator Light turns green but the unit does not flash when the
button is pressed.
Make sure the Skin Contact Sensor is in full contact with the skin.
Try resetting the unit by turning it off and waiting several seconds before turning it
back on.
There is a strange smell.
Be sure the area is completely shaved before treatment.
The treated areas become red after treatment.
This is normal and the redness should subside. If not, try using a lower light intensity.
I have not seen optimal results or hair has begun to grow back.
Hair may begin to grow back after your initial treatment. This is perfectly normal. For
optimal results, repeat the treatment when you notice hair regrowth.
Intensity/Flash Mode LED
All
currently
selected
LEDs flashing
Intensity LEDs flashing
i
n
sequenc
e
All
LEDs
flashing
with
warning
beep
Indication
U
nit is overheated and is disabled momentarily to cool down.
Unit is malfunctioning. Turn the unit off, wait a few moments and try
again. If problem persists, the unit should be returned for repair.
Nose cone is removed or loose.
Audible Tones
Not Full Contact
Replace Light Cartridge
Contact Sensors Stuck
Indication
Flash button was pressed while the skin contact sensor was not
fully engaged.
Light cartridge is missing or needs to be replaced.
Flash button was pressed after the contact sensor had been
engaged since unit start up. Contact sensor may be stuck.
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments