Remington i-Light IpL5000 Troubleshooting Guide download pdf (Page 12)

Getting Acquainted With i-Light

Light Cartridge (fig. 1-G)

Each light cartridge has a life of 1,500 flashes. When all flashes have been

used, the cartridge must be replaced.

Replacement model: SP-IPL

Intensity Level Selection

(fig. 1-L)

The i-Light device is equipped with 5 intensity levels. Level 1 is the lowest set-

ting and level 5 is the highest setting.

TIP: For the most effective results, always use the highest intensity level that does not

cause discomfort on the skin. To determine the intensity level being used, observe

the number of lights illuminated on the Intensity Level Selection Display.

Your i-Light device will automatically be set to Intensity Level 1 each time the

device is powered ON. To change the level, press the Intensity Level Selection

Button.

Flash Mode Selection (fig. 1-N)

The i-Light device is equipped with two operating modes: Single Flash Mode

and Multi-Flash Mode. Your i-Light device will automatically be set to Single

Flash Mode each time the device is powered ON.

Single Flash Mode: The i-Light device will flash once when the Flash Button is

pressed AND the skin contact sensor is engaged.

Multi-Flash Mode: The i-Light device will flash once every two seconds when the

Flash Button is pressed AND the skin contact sensor is fully engaged.

The Multi-Flash Mode allows you to quickly treat large areas such as the legs, chest

or back by simply gliding the hand piece to a new location after each flash.

To turn Multi-Flash Mode ON, press the Multi-Flash Mode Selector Button.

The Multi-Flash Mode Selector Display will illuminate. Press again to turn

Multi-Flash Mode OFF and return to Single-Flash Mode.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

No comments

Remington i-Light IpL5000 Troubleshooting Guide Page 12