Remington 500V User Manual download pdf (Page 19)

106763

B. REMOVING HANDLE PAD ASSEMBLY

1. Loosen screw on back of handle pad assembly with 3mm hex wrench. Do not

remove the screw from the assembly (see Figure 5).

2. Remove handle pad assembly.

3mm Hex Wrench

Figure 5 - Removing Handle Pad Assembly

Handle Pad Assembly

C. REMOVING REAR PAD AND POWER INDICATOR ASSEMBLY

1. Keeping pressure against the back of the rear pad and power indicator assembly,

loosen screws using a 3mm hex wrench. Slowly release pressure.

Note:

Rear

pad and power indicator assembly is spring loaded. Pressure should be kept on

the assembly at all times while loosening screws to avoid loosing parts.

2. Pull rear pad and power indicator assembly out of housing (see Figure 6).

Figure 6 - Removing Rear Pad and Power Indicator Assembly

Screws

Rear Pad and Power

Indicator Assembly

Housing

Figure 7 - Removing Rocker Arm Assembly from Housing

Rocker Arm Spring

Rocker Arm Pin

Rocker Arm Assembly

D. REMOVING ROCKER ARM ASSEMBLY

1. Remove the larger spring from the outside of the outer liner assembly and the

firing pin spring from inside the outer liner assembly (see Figure 7).

2. Remove rocker arm pin with hammer and punch.

3. Remove rocker arm assembly from housing (see Figure 7).

Firing Pin Spring

Spring

Housing

Continued

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

Remington 500V User Manual Page 19