Remington M15012US Owner's Manual download pdf (Page 11)

ASSEMBLY

Pull the guide bar away from the saw body

so that the guide bar is fully extended and the

slack i'_removed from the chain (See Figure

10 Finger tighten the guide bar nut onto the guide

bar bolt (See Figure 81

Figure 6 - Pulling Guide Bar

Insert the sprocket cover tab into the saw body

tab slot, Step 1 Then lower sprocket cover

onto guide bar bolt, 5uT 2 [See Figure 7)

NOTE: At this point tile sprockel cover will

no___Jbe flush against the saw body

....... Guide

Bar Nut

Figure 8 - Guide Bar Belt

t 1. Slowly slide guide bar into saw body until the

adjustment block goes into 1.11oround adjusting

hole on the guide bar (See Figure 6) NOTE:

This locks the guide bar in place You should

not be able to push or pull the guide bar

I2 Retighten the b.'tr nut linger tight.

13. Adjust the saw chain lension Follow the steps

under Sm_ Chait, Tett_ion Adju_tttl_nt

TabSlot SprocketCoverTab

J:i

Sprocket Cover Tab

Figure 7 - Installing Sprocket Cover

11 www,mmlngtonpowerf_olscorn

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 74 75

No comments

Remington M15012US Owner's Manual Page 11