Remington MB4010 User Manual download pdf (Page 3)

4 5

ENGLISHENGLISH

Comb Position Cutting Length

1 1.5mm

2 4.5 mm

3 7. 5m m

4 10.5 mm

5 13.5mm

6 16.5mm

0.5mm length is achieved without any combs

,To thin and taper beards or moustaches

• Attach the adjustable comb to the trimmer blade and select the desired length.

• The setting will appear on the length position indicator. If you are trimming for the rst

time start with the maximum trimming length setting

• Turn the unit on.

• Place the at top of the trimmer comb against the skin

• Slowly slide the trimmer through the hair. Repeat from dierent directions as necessary.

,To dene the beard/moustache line

• Remove the trimmer comb attachment

• Start with edge of beard/moustache line and gently lower the trimmer blade onto

yourskin.

• Use motions towards edge of beard/moustache line to trim to desired locations in facial

area and away from beard in neck area.

,Trimming edge of sideburns

• Start with edge of sideburn, and with the trimmer blades resting lightly against your

skin, use motions towards edge of sideburn line to trim to desired locations in facial area.

,Trimming the nape of your neck

Note: You will need a hand mirror for this operation if performing it alone.

• Use your ngers to lift the hair at the base of your head up o the neck. Your index nger

should be covering the roots of the hairs you are lifting to prevent accidental removal by

trimmer.

• Using your other hand, hold the trimmer to the base of your neck with the cutting unit

facing up, and move the trimmer up the length of the neck until it touches your nger

covering the hair roots at the base of your head.

• Be sure to move the unit slowly when performing this operation and to keep the hair

roots at the base of your head out of the way of the trimmer.

C REMOVING THE TRIMMER COMB, ATTACHMENT AND CUTTING

ASSEMBLY

• Hold the trimmer in one hand, with your other hand, gently pull the trimmer comb

attachment o the trimmer.

• Remove the cutting assembly by rmly pushing up on the

blade with your thumb.

C REPLACING THE CUTTER ASSEMBLY

• Hold the trimmer in one hand. With your other hand, insert the lower part of the cutter

assembly into the trimmer, push down the cutter until rmly attached.

C REPLACING THE TRIMMER COMB

• Hold the trimmer in one hand.

• Slide the comb/shaver down the grooves until it clicks into place.

Note: The trimmer comb attachment can only be placed on the trimmer one way; if it

does not t properly remove and reverse it.

ETips for best results

• Beard, moustache and sideburn hairs should be dry.

• Avoid using lotions before using your trimmer. Comb your hair in the direction that it

grows.

• Remove trimmer comb attachment if you are: dening hairline edges such as

sideburns, trimming the nape of your neck, trimming your beard line on front of neck

C CARE FOR YOUR TRIMMER

Care for your trimmer to ensure a long lasting performance Your trimmer is tted with

high-quality, cutting blades that are permanently lubricated.

Cleaning should only be done with a soft brush.

E After each use

• Turn the trimmer o.

• Remove trimmer comb attachment and cutter assembly.

• Gently brush the remaining hairs away.

A CLEANING CAUTIONS

• Only the trimmer comb attachment and trimmer blade may be removed from the

product for cleaning.

1 2 3 4 5 6 7 8 ... 57 58

Comments to this Manuals

No comments

Remington MB4010 User Manual Page 3

Comments to this Manuals

Related products and manuals for Hair clippers Remington MB4010