Remington BS1812A User Manual download pdf (Page 7)

7

www.desatech.com

RECHARGEABLE BATTERY

4. Unplug charger. Remove the battery pack

by sliding out (See Figure 3).

5. Place the battery pack in the tool and be

certain that it is inserted fully into the tool

cavity until it “clicks” into place.

The charger is designed to use standard house-

hold 120 volt 60 Hz power

1. Plug cord from charger into charger base.

(See Figure 1)

The battery pack is not fully

charged at the factory. Before

attempting to charge the bat-

tery pack, thoroughly read all

Safety Instructions.

2. Plug the charger into any standard 120

Volt 60 Hz electrical outlet. Important:

Do not charge by means of an engine

generator or DC power source. Use only

120V AC.

3. Slide the charger onto the battery pack as

shown in Figure 2. The LED will light up,

Let the battery pack charge until red LED

turns off. After the initial charge, under

normal usage, your battery pack should

be fully charged in 3 to 9 hours.

IMPORTANT CHARGING NOTES

1. After normal usage, your battery pack

should be fully charged in 3 to 9 hours. If

the battery pack is run-down completely,

it may take up to 9 hours to become fully

charged. Your battery pack was sent from

the factory in an uncharged condition.

For best performance charge battery until

red LED turns off. Allow the battery to

cool down 30 minutes before charging

after using the trimmer/edger. NOTE: A

hot battery placed in the charger will not

charge.

2. DO NOT charge the battery pack in an

air temperature below 40°F (4,5 °C) or

above 105°F (40,5 °C). This is important

and will prevent serious damage to the

battery pack. Longest life and best per-

formance can be obtained if battery pack

is charged when air temperature is about

75°F (24°C).

3. While charging, the charger may hum

and become warm to touch. This is a

normal condition and does not indicate a

problem.

4. If the battery pack does not charge prop-

erly

• Check current at receptacle by plugging

in a lamp or other appliance.

• Check to see if receptacle is connected

to a light switch which turns power off

when you turn out the lights.

• Move charger and battery pack to a

surrounding air temperature of 40°F

(4,5°C) to 105°F (40,5 °C)

• If the receptacle and temperature are

OK, and you do not get proper charging

contact DESA Power Tools.

5. The battery pack should be recharged

when it fails to produce sufﬁ cient power

on jobs which were easily done previ-

ously. DO NOT CONTINUE using

product with its battery pack in a depleted

condition.

6. To prolong battery life, avoid leaving

the battery pack on charger for extended

periods of time (over 30 days without

use). Although overcharging is not a

safety concern, it can signiﬁ cantly reduce

overall battery life.

7. The battery pack will reach optimum

performance after being cycled 5 times

during normal usage. There is no need to

run the batteries down completely before

recharging. Normal usage is the best

method of discharging and recharging the

batteries.

Figure 1 - Plug Charger into Base

Figure 3 - Remove Charger

CHARGING BATTERY

Figure 2 - Sliding Charger onto Battery

ENGLISH

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comments to this Manuals

No comments