Remington BS1812A User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
15
www.desatech.com
TROUBLESHOOTING
OBSERVED FAULT POSSIBLE CAUSE REMEDY
Trimmer/Edger does not start wen you
squeeze the trigger.
1. Battery not installed properly.
2. Battery not charged.
3. Trigger lockout button not
depressed prior to squeezing trigger.
1. Verify proper installation of bat-
tery.
2. Insure battery is charged per re-
quirements.
3. Follow directions outlined in basic
trimmer operation.
Trimmer/Edger runs slowly or stalls
easily.
1. Battery is nearly depleted. 1. Recharge battery completely.
Line does not feed when you tap the
line advance button.
1. All the line has been used on spool.
2. Line has retracted into spool.
3. Line is caught or tangled on spool and
will not feed.
1. Install new line on spool.
2. Remove spool and pull line out,
then replace spool.
3. Remove spool, loosen and un-
tangle line, then replace spool.
Battery discharges quickly. 1. Battery not fully charged.
2. Battery worn and will not hold
charge.
1. Recharge battery completely.
2. Replace battery.
Battery not charging. 1. Charger not plugged in.
2. Battery not fully inserted into charger
base.
3. Charger cord not properly connected
to charger base.
4. Charger damaged.
1. Plug charger into 120V 60Hz AC
source.
2. Insure battery is inserted correctly
in charger base.
3. Insure charger cord is fully inserted
into charger base.
4. Replace charger.
ENGLISH
Note: For additional help, visit our technical service web site at www.desatech.com.
WARNING: Remove battery before servicing. Severe injury or death could occur from
re, electrical shock or rotating line.
SAVE THESE
INSTRUCTIONS
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comments to this Manuals

No comments