Remington BS1812A User Manual download pdf (Page 12)

12

www.desatech.com

TRIMMER/EDGER OPERATION

Figure 21 - Unlocking spool cover

Figure 23 - Cleaning spool

Figure 24 -Inserting line through eyelet

Figure 26 - Inserting line through housing

FPO

Figure 22 - Removing spool cover and

spool

Replacing Trimmer/Edger Line

For replacement line, use a nylon monoﬁ la-

ment line of 0.065 inch in diameter. You can

purchase replacement line at most lawn and

garden stores.

To prevent serious personal

injury, never use metal-re-

inforced line, wire, or rope,

etc. These can break off

and become a dangerous

projectile.

Use of line other than speci-

ﬁ ed could cause personal

injury or product failure.

Direction

of Line

Feed

Direction

of Line

Feed

Figure 25 -Winding Line Around Spool

WARNING:

CAUTION:

REMOVING THE SPOOL

1. Press in the two locking tabs holding the

spool cover to the spool housing (See

Figure 21).

2.

Remove the spool cover and spool

from spool housing (See Figure

22). Note: If spool spring comes off of spool

housing, replace spring into center of spool

housing. Note: If installing replacement

spool and line (P/N BRS65A), skip to step

8. Remove and discard any remaining line

in the spool.

3. Clean grass and other debris from the

spool and spool housing using a brush

(See Figure 23).

4. Insert 1 inch of line through small hole at

the base of spool (See Figure 24).

5. Evenly and tightly wind line around spool

in the direction shown on bottom of spool.

Continue winding until line is just below

rim of spool. (See ﬁ gure 25). Do not over

ﬁ ll. Overﬁ lling can cause jams.

6. Cut the line. Keep tension on line so line

does not unwind.

7. Insert cut end through eyelet in spool

housing. (See Figure 26)

8. Replace spring and spool into spool hous-

ing making sure line is not caught under

spool. (See Figure 27, page 13)

9. Align tabs on spool cover with slots in

spool housing. Replace spool cover onto

spool housing and snap into place. (See

Figure 28, page 13)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments