Remington RM1822BH Operator's Manual download pdf (Page 2)

• Iftheextensionistobeusedoutside,thecordmustbesuitableforoutdooruse.Anycordmarked

foroutdoorusecanalsobeusedforindoorwork.Theletters"W"or"WA"onthecordjacket

indicatethatthecordissuitableforoutdooruse.

• A2-wireextensioncord(onewithoutaground)maybeused.However,a3-wireextensioncord

(onewithaground)thatusesaNEMA-typeconnector(parallelblade,Uground)isrecommended.

Extensioncordsareavailablefromlocalretailers.

Makesuretheextensioncordisheavyenoughtocarrythecurrentdrawnbytheunit.An

undersizedcordwillcauseadropinlinevoltageresultinginlossofpowerandoverheating.Ifin

doubt,usethenextheaviergaugecord.Thesmallerthegaugenumber,theheavierthecord.

MINIMUM WIRE SIZE FOR EXTENSION CORDS

FOR 120 VOLT APPLIANCES USING 0-10 AMPS

Cord Length (feet} 25 50 100 150

Wire Size (AWG) 18 18 16 14

A nameplate on your unit indicates the voltage used. Never connect the unit to an AC voltage that

differs from this voltage.

Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) that

will be used with the unit. For an extra measure of safety, use receptacles with built-in GFCI protection.

HEDGE TRIMMER SAFETY

• DO NOT over reach.

• DO NOT cut above shoulder height.

• DO NOT operate the unit with one hand! Serious injury to the operator, helpers or bystanders may

result from one-handed operation. This unit is intended for two-handed use. Always grip the unit

firmly with both hands when the motor is running. Keep the left hand on the front handle and the

right hand on the rear handle. Use a firm grip with thumbs and fingers encircling the handles.

• DO NOT use the front hand guard as a handle.

• DO NOT operate the unit on unstable surfaces, such as trees, ladders, slopes or rooftops. Be very

careful when using the unit on stairs.

• DO NOT force the unit. It will do a better, safer job when used at the intended rate.

• DO NOT leave the unit unattended while the battery is installed. Remove the battery from the unit

when not in use.

• Inspect the work area before using the unit. Remove any hard and/or sharp objects, such as glass,

wire, etc. If thrown or caught in the trimmer blade, such objects could cause property damage or

injury to the operator or bystanders.

• If the unit strikes or becomes entangled with a foreign object, stop the motor immediately, remove

the battery and check for damage. Do not restart or operate the unit before repairing damage.

• Keep hair, loose clothing, fingers and all other body parts away from openings and moving parts.

• Keep proper footing and balance at all times.

• Before starting the unit, make sure the trimmer blade is not contacting anything.

• Always begin a cut with the motor running at full speed.

• Always stop the motor when operation is delayed, before setting down the unit or when walking

from one location to another. Make sure the unit comes to a complete stop.

• To avoid accidental starting, never carry the unit with fingers on the switch trigger.

• Always carry the unit by the front handle with the battery removed, finger off the switch trigger and the

trimmer blade positioned to the rear.

• Always make sure the switch lock is in the locked or OFF position before installing or removing the battery.

• This unit is intended for infrequent use by homeowners. It is not intended for prolonged use.

• For safer, more effective performance, make sure the trimmer blade is sharp, properly cleaned and

free from obstructions. Follow all lubrication instructions.

MAINTENANCE AND STORAGE SAFETY

• DO NOT operate a unit that is damaged, improperly adjusted or not completely and securely

assembled. Be sure that the unit stops when the trigger is released. Do not use the unit if the

switch does not turn the unit on and off properly or if the switch lock does not work. Have defective

switches replaced by an authorized service center.

• If the unit is not working as it should, has been dropped, damaged, left outdoors or dropped into

water, do not use the unit. Have the unit serviced by an authorized service center.

• All service, other than the maintenance procedures described in this manual, should be performed

by an authorized service center. Do not attempt to repair; there are no user serviceable parts inside.

• Follow all maintenance instructions in this manual.

• Before inspecting, servicing, cleaning, storing, transporting or replacing any parts on the unit:

1. Make sure the switch lock is in the locked or OFF position.

2. Make sure all moving parts have stopped.

3. Remove the battery.

4. Allow the unit to cool.

• Never remove, modify or make inoperative any safety device furnished with the unit.

• Frequently inspect the unit for damage. Before further use, any damaged part should be carefully

checked to determine that it will operate properly and perform its intended function. Check for

alignment of moving parts, binding of moving parts, breakage of parts and any other conditions that

may affect its operation. Damaged parts should be properly repaired or replaced by an authorized

service center, unless otherwise indicated in this manual.

• If the unit starts to vibrate abnormally, stop the motor, remove the battery and allow the unit to cool.

Then inspect the unit for the cause of the vibration. Vibration is generally an indicator of trouble.

• Use only original manufacturer replacement parts and accessories, which are designed specifically to

enhance the performance and maximize the safe operation of the product. Failure to do so may cause

poor performance and possible injury.

• Remove the battery from the unit when not in use.

• Be sure to secure the unit while transporting.

• When not in use, store the unit indoors in a locked-up and dry, or high and dry, place to prevent

unauthorized use or damage. Keep out of the reach of children.

• Keep the handles dry, clean and free from debris, oil and grease. Clean the unit after each use.

Never douse or spray the unit with water or any other liquid. Do not wash the unit with a hose; avoid

getting water in the motor and electrical connections. Do not use solvents or strong detergents.

,, SAFETY AND INTERNATIONAL SYMBOLS ,,

This operator's manual describes safety and international symbols and pictographs that

may appear on this product. Read the operator's manual for complete safety, assembly,

operating, maintenance and repair information.

SYMBOL MEANING

san:_

_Vst_

_a I_;_

:o_

Sav_

_¢j_roi

SAVE THESE INSTRUCTIONS

APPLICATIONS

This unit may be used for the purposes listed below:

Trimming and forming hedges, shrubs and bushes with a branch diameter of up to 7/16 of an

inch (11.1 mm).

NO TOOLS REQUIRED!

Front

Handle

Blade Support \

Battery

RemeaseButton

1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments

Remington RM1822BH Operator's Manual Page 2

Comments to this Manuals

Related products and manuals for Power hedge trimmers Remington RM1822BH