Remington RM1630U Specifications download pdf (Page 11)

ASSEMBLY

Pull the guide bar away fiom the saw body

so that the guide bar is fully extended and the

slack is removed fiom the chain. (See Figure

10. Finger tighten the guide bar nut onto the guide

bar bolt. (See Figure 8).

Guide

Bar Nut

Figure 6 - Pulling Guide Bar

Insert the sprocket cover tab into the saw body

tab slot, Step 1. Then lower sprocket cover

onto guide bar bolt, Step 2 (See Figure 7).

NOTE: At this point the sprocket cover will

not be flush against the saw body.

Figure 8 - Guide Bar Bolt

11. Slowly slide guide bar into saw body until the

adjustment block goes into the round adjusting

hole on the guide bar. (See Figure 6) NOTE:

This locks the guide bar in place. You should

not be able to push or pull the guide bar.

12. Retighten the bar nut finger tight.

13. Adjust the saw chain tension. Follow the steps

under Saw Chain Tension Adjustment..

Tab Slot Sprocket Cover Tab

Sprocket Cover Tab

Figure 7 - installing Sprocket Cover

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 73 74

No comments

Remington RM1630U Specifications Page 11