Remington R-800 Owner's Manual download pdf (Page 13)

Firing Your Rifle

Once a round is chambered and you are ready to commence firing, move the Safety Selector from

SAFE

FIRE

Aim at the target.

Pull or squeeze the trigger.

As the rifle fires, release the trigger.

The Rifle will automatically eject the spent Cartridge and chamber another in preparation for the next shot.

The cycle of pulling the Trigger to shoot, and the Rifle automatically reloading, can be continued until the

Magazine and chamber are empty. If you stop firing before the chamber is empty, immediately place the Safety

Selector in the

SAFE

position.

NOTE:

After the last Round is fired, the Bolt Carrier will lock in the rear position.You can then push the

Magazine Release Button to drop out the empty magazine, insert a fresh Magazine, release the Bolt Catch,

and a new Round will be automatically chambered in preparation for the next firing sequence.

WARNING IF A NOTICEABLE DIFFERENCE IN SOUND OR RECOIL IS

EXPERIENCED, STOP FIRING IMMEDIATELY.

Either condition could indicate an incomplete powder burn and/or a bullet stuck in the bore. Remove the

Magazine and retract the bolt to empty the chamber. Check for unburned powder grains

in the Receiver or Bore, and for a Bullet stuck in the Bore (see Page 16). Clean out any unburned powder before

resuming firing. If a Bullet is stuck in the Bore, do not attempt to remove it. Take the Rifle to a Remington

Authorized Repair Center for removal.

WARNING… DO NOT LOAD WITH A HOT CHAMBER – A ROUND MAY “COOK OFF”.

“Cooking Off” means that a Round may Detonate (Fire) unexpectedly just from being exposed to the heat of the

Rifle’s Firing Chamber.

Unloading Your Rifle

WARNING ALWAYS KEEP THE MUZZLE POINTED IN A SAFE DIRECTION

THROUGHOUT THE LOADING PROCESS!

Place Safety Selector on

SAFE

Press Magazine Release Button and remove Magazine.

Pull Charging Handle to rear. Press lower portion of Bolt Release. Bolt should lock open. If a round

was in the chamber, it should have been ejected. If last round was fired, bolt should already have been

locked to the rear.

Visually check chamber through ejection port to make sure chamber is empty.

With the Magazine removed and the chamber empty, you may now close the bolt by depressing the top

portion of the Bolt Release which will allow the bolt to return forward on the empty chamber.

Empty the Magazine by sliding the remaining cartridges forward and out of the Magazine.

CONDITION:

The rifle and magazine are now completely unloaded.

Securely store ammunition and rifle seperately

38429 DPMS_1.qx6.qxd 6/9/08 12:05 PM Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments

Remington R-800 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Men's shavers Remington R-800