Remington MB-100 Owner's Manual download pdf (Page 13)

4. Put one hand over the top of the ejection port.

5. Slowly pull the bolt handle rearward with your other hand to remove the cartridge from the chamber.

6. Depress both latches to release magazine box. See Picture 12 on page 11.

7. Remove all cartridges from the magazine box.

8. Replace the magazine box.

WARNING! Check the chamber and the magazine to make sure there are no cartridges in the firearm.

To Adjust Sights

TO ADJUST THE REAR SIGHT:

Move the rear sight in the same

direction as you need to move the

bullet on the target. See Picture 15.

NOTE: For more on ballistics and trajectory, see the REMINGTON

catalog.

For the Model 673

™ ONLY. The rear sight elevation screw is located

ahead of the rear sight aperture. The point of aim is adjusted by using a

1/16” hex wrench. To raise the point of impact turn the elevation screw

clockwise. See Picture 15a.

The ventilated rib is screwed to the barrel and is isolated through the use

of synthetic buffers, both above and below the rib. The design allows the

rib to “float”. In this way the barrel moves independently of the rib

ensuring accuracy. Disassembly is

recommended.

TELESCOPIC SIGHTS:

The top of the receiver has holes for the installation of telescopic

sights.

Lubrication and

Maintenance

When the firearm is to be

stored, it should be carefully

cleaned and thoroughly oiled.

Outside surfaces should be

wiped with a light coat of

Rem

™ Oil occasionally. When

firearm is to be reused, all excess lubrication

must be removed. The chamber and bore

must be thoroughly wiped dry.

NOTE: Remington

Rem™ Oil is available

from your local dealer. If your dealer is out of

stock, ask him to order Rem™ Oil from his

Remington distributor.

REAR SIGHT APERTURE

PICTURE 15a

WINDAGE SCREW

ELEVATION SCREW

PICTURE 15

REAR SIGHT APERTURE

EAR SIGHT SLIDE

WINDAGE SCREW

ELEVATION SCREW

All models with sights are

adjusted at the factory to

it a target at 100 yards.

POSITION ON

TARGET

ADJUSTMENT

Bullet hits above

the center.

Bullet hits below

the center.

Bullet hits to

the left.

Bullet hits to

the right.

a. Loosen the elevation screw on the

right side.

b. Slide the rear sight down (backward)

on the ramp.

c. Tighten the elevation screw.

a. Loosen the elevation screw on the

right side.

b. Slide the rear sight up (forward)

on the ramp.

c. Tighten the elevation screw.

a. Loosen the windage screw on the

right side.

b. Slide the rear sight aperture to the

right.

c. Tighten the windage screw.

a. Loosen the windage screw on the

right side.

b. Slide the rear sight aperture to the

left.

c. Tighten the windage screw.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Remington MB-100 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Grass trimmers Remington MB-100