Remington BRANCH WIZARD RM0612P Owner's Manual download pdf (Page 8)

8

Guide Bar

Guide Bar

Nut

Bushing

Sprocket Cover

Belleville Washer

Saw Chain

Towards Guide Bar Nose

Cutting Edge

IMPORTANT: Read and understand this

manual before assembling or operat-

ing this Pole Saw. Improper use of Pole

Saw can cause severe injury. Keep this

manual for future reference.

Note: Some models are pre-assembled. Assembly

is not needed on these models.

See Saw Chain Tension Adjustment.

1. Lay chain out ﬂat.

2. Loosen and remove guide bar nut, sprocket

cover, and washer (see Figure 1).

3. Install guide bar onto saw body. Place center slot

of guide bar onto guide bar bolt.

4. Place chain around drive sprocket, then along

top groove of guide bar and around guide bar

nose. Note: Make sure cutting edges of chain

are facing the right direction. Position chain so

cutting edges on top of guide bar face guide bar

nose (see Figure 2 and indicator on side cover

of Pole Saw).

WARNING: Cutting edges on chain

are sharp. Use protective gloves when

handling chain.

IMPORTANT: Do not clamp Pole Saw in

vise during assembly.

5. Place Belleville washer, sprocket cover, and

guide bar nut onto Pole Saw. IMPORTANT:

Make sure serrated edge of the Belleville washer

is positioned as shown in Figure 3. The serrated

edge must be in contact with the guide bar.

IMPORTANT: Tighten guide bar nut ﬁ nger tight

only.

6. Adjust saw chain tension. Follow steps under

Saw Chain Tension Adjustment.

ASSEMBLY

Figure 1 - Installing Guide Bar

Figure 2 - Chain Position

CAUTION: Do not place chain on saw

backwards. If chain is backwards, saw

will vibrate badly and will not cut.

Figure 3 - Belleville Washer Assembly

Guide Bar

Serrated Edge Against

Guide Bar

Belleville Washer

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments