Remington R-9500 User Manual download pdf (Page 7)

13

When is it time to replace

your head assembly?

Because they are subject to daily use, the

heads and cutters of your Remington

®

shaver

will wear and eventually require replacement.

It is very important to replace your heads and

cutters when necessary to insure a close,

comfortable shave. Depending on your shaving

technique and habits:

H

ead and cutter assemblies will usually last

12 months. Worn or damaged parts should be

replaced with Remington

®

replacement parts

only. The replacement head asssembly for the

R-9500 is SP-21.

When it’s time to

replace the cutters,

model R-9500

displays a cutter icon.

Irritation

As the heads get excessively worn there

may be some skin irritation. This would be

especially noticed when applying after-

shave lotion.

Pulling

When the cutters wear you may feel a

sense of pulling and a loss of closeness

when you shave. This is an indication that it

is time to replace your heads and cutters.

! Do not remove or replace the head

assembly while shaver is running or

plugged into an electrical outlet as it may

cause damage to the unit’s cutters.

Maintenance

Battery Removal

When your rechargeable shaver reaches

the end of its useful life, the batteries must

be removed from the shaver and be recy-

cled or disposed of properly in accordance

with your state and local requirements. If

this is not required by law, you may elect to

dispose of the shaver without removing the

batteries.

THE FOLLOWING PROCEDURE SHOULD BE

FOLLOWED FOR BATTERY REMOVAL:

1. To avoid a possible electric shock

hazard, unplug cord from electrical outlet

and shaver.

2. Open the head assembly

by pressing the head

release buttons and lifting

the head assembly. Pull the

entire head assembly off

of the shaver assembly.

3. Push the trimmer button

up to open the trimmer.

4. Remove the trimmer

assembly by squeezing

the sides as shown in the

picture.

5. Using a small Phillips head

screwdriver, remove the 3

screws from the back of

the shaver.

6. Pull or gently pry the

shaver halves apart,

exposing

the battery.

7. Pry the lower battery

clip off.

8. Lift or pry the batteries out of the shaver.

9. Cut the wires on both ends of each

battery and remove them from the shaver.

CAUTION: DO NOT PUT IN FIRE OR MUTI-

LATE YOUR BATTERIES WHEN DISPOSING

AS THEY MAY BURST OR RELEASE TOXIC

MATERIALS. DO NOT SHORT CIRCUIT AS IT

MAY CAUSE BURNS. DISPOSE PROPERLY IN

ACCORDANCE WITH YOUR LOCAL AND

STATE REQUIREMENTS.

2

3

4

6

12

Interior Cleaning

For optimal results,

gently wipe this

area clean with a

damp cloth every

6 months.

! To prevent inadvertent damage to the

cutter assembly, do not attempt to remove it

unless you are replacing it. When it’s time

to remove the cutter assembly, follow

the instructions that come with the

replacement package.

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

Comments to this Manuals

No comments