Remington R-225 User Manual download pdf (Page 5)

9

To assure smooth, efficient

performance, it is important

to clean your shaver.

Daily

Brush inside the

head assembly

after each use:

1. Turn the shaver

off.

2. Grip the head

assembly by

the

three ridges

and pull it off the

shaver.

3. Use the clean-

ing brush to

sweep out the

internal part of

the head assem-

bly and the hair

pocket area,

where 3 shaver

spindles are

located.

4. Replace head assembly.

Weekly

Clean under the cutter assembly at

least once a week:

1. Turn the shaver off.

2. Open the head assembly as above.

3. Unscrew the center screw knob

to remove the cutter retainer

assembly.

4. Use the cleaning brush to sweep

the dust and hairs from under the

cutters.

5. Replace head assembly.

Cleaning Cautions

■ The construction of this shaver

is for dry operation only. It is

not waterproof. Never put the

shaver partially or completely

into water.

■ Never clean the shaver or

replace the cutters while it is

plugged into an electrical outlet.

■ Do not use an aggressive cleansing

agent as this may destroy the

shaver coatings.

■ Do not clean or remove the head

assem

bly while the shaver is running

or plugged

in, as it may cause dam-

age to the unit's heads or cutters.

■ Replace worn or damaged parts

with Remington

®

replacement

parts only.

8

When is it Time to Replace

Your Heads and Cutters?

It is very important to replace your

heads and cutters when necessary

to ensure a close,comfortable

shave without irritation.We recom-

mend they be replaced every 12

months. Here are some signs of

head and cutter wear, indicating

that replacement is needed.

Irritation

As the heads get excessively worn

you may experience some skin

irritation.This would be especially

noticeable when you apply

after-shave lotion.

Pulling

When the cutters wear you may

feel a sense of pulling and a loss

of closeness when you shave.This

is an indication that it is time to

replace your heads and cutters.

The replacement parts for your

shaver is model SP-25.

U.S. residents: To order, contact

us at 800-231-8793, visit us at

www.remington-products.com

or visit your local retailer.

Canadian residents: For any shaver

accessory requirements, please

call

800-268-0425 or

visit us at

www.remington-products.com

Head/frame

assembly

Floating

cutter

heads

Locating pins

Cutter retainer

assembly

Center

screw

knob

Locating holes

Lubricate

Remington

®

Shaver Saver

®

Lubricant

(SP-4)

lubricates and cleans your

shaver's cutters and head assembly.

The lubricant helps remove hair clip-

pings while reducing wear.A quick

spray after each shave keeps

your

shaver operating at peak performance.

! Important: Make sure to align

the two locating holes in the Cutter

Retainer assembly with the pins in

the Head Frame Assembly. (See

illustration below).Then tighten

center screw knob to lock the

cutters into place.

Replace head assembly on the shaver

simply by pushing it onto the shaver.

Cover shaver head with plastic head-

guard between uses.When removing

the headguard or placing it back onto

the shaver,do not apply pressure to

floating cutter surfaces, as you may

damage them.

Cleaning and Maintenance

Microflex R_200_400_IB 8/24/06 2:34 PM Page 8

1 2 3 4 5 6 7

Comments to this Manuals

No comments