1312
Prepare the device for treatment
3. Unwrap the hand piece cord from the i-Light base and rest the hand piece in the base
cradle. Locate the power switch on the i-Light base and ensure the unit is OFF. Connect
the power cord to the i-Light base at the power inlet. Connect the power cord to the wall
outlet. Turn the power switch ON. (fig. 9)
4. Use the skin sensor to unlock the unit. (fig. 6)
You must unlock the unit on each body part you wish to treat
5. Select the desired Energy Level. (fig. 10)
Ifyourskinisunsuitable,theappliancewillbuzzandremain
Fig 8
Fig 9
Fig 10
✹ Treat body area(s) with the i-Light device
The i-Light device is equipped with two operating modes: Single Flash Mode and Multi-Flash
Continuous Function. Your i-Light device will automatically be set to Single Flash Mode each
time the device is powered ON.
Single Flash Mode:Thei-Lightdevicewill
oncewhentheFlashButtonispressedAND
skin contact sensor is engaged.
Multi-Flash Continuous Function:
Flash Button is pressed AND the skin contact sensor is fully engaged.
The Multi-Flash mode allows you to quickly treat large areas such as the legs, chest or back
by
simplyglidingthehandpiece toanewlocationaftereach
✹ Single Flash Mode
1.Placethei-LighthandpieceagainstyourskinsotheFlashWindowis withtheskin
surface. (fig. 11)
2. Ensure the Skin Contact Sensor is fully engaged and the Bulb Status Indicator Display
is illuminated.
3. Press the Flash Button to activate the device (fig. 12).
4. Move the hand piece to a new treatment area and repeat steps 1-3 (fig. 13).
Multi Flash Continuous Function
1.
handpieceagainstyourskinsotheFlashWindowis withtheskin
surface (fig. 11)
2. Ensure the Skin Contact Sensor is fully engaged and the Bulb Status Indicator Display
is illuminated.
3. Press AND HOLD the Flash Button down to activate the device (fig. 12).
4.Immediatelyafterthedevicehas
slidethehandpiecetoanewlocation.Aftera
shortdelay(approximately2seconds)thedevicewill again 13).
NOTE:
• DuringMulti-FlashMode,theSkinContactSensorANDtheFlashButtonmustremainfully
depressed. If either becomes disengaged, the device will not operate. To resume
treatment, repeat steps 1-4.
• DuringMulti-FlashMode,theBulbStatusIndicatorDisplaywillremainilluminatedwhile
the Skin Contact Sensor and Flash Button are engaged.
Fig 11 Fig 12 Fig 13
✹
™
Comments to this Manuals