Remington HH-70T-KFA Troubleshooting Guide download pdf (Page 9)

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR

WHILE CONNECTED TO A POWER SOURCE

2SHUDWLRQ

6WDUWLQJWKH+HDWHU,JQLWLRQ

1. Fill the tank with kerosene or other approved

fuel until needle on fuel gauge points to “F”.

2. Replace fuel cap and tighten firmly.

3. Connect the heater to a three prong

(grounded) power source. You must use a

three prong (grounded) extension cord that

is at least 6 feet long and is a minimum of 14

AWG rating.

Model 45-KFA:

1. Complete steps 1-3 above.

2. Move power switch to “On” position. The

power indicator light will illuminate and the

heater will ignite. (See Figure 9)

127(,ILIWKHKHDWHUVWLOOGRHVQRWLJQLWHUHIHUWR

 ³7URXEOHVKRRWLQJ*XLGH´RQSDJH

6WRSSLQJ5HVWDUWLQJ+HDWHU

- To stop the heater, move the power switch to the

“Off” position and unplug the power cord.

- To restart the heater; wait 10 seconds and follow

ignition steps.

Models 70T-KFA / 125T-KFA / 175T-KFA / 215T-KFA:

1. Complete “starting heater ignition” steps 1-3

above

2. Turn thermostat control knob to desired

temperature setting. The thermostat set range

is from 40 ºF to 110 ºF.

3. Move power switch to “On” position. The

power indicator light and room temperature

display will illuminate and heater will ignite.

(See Figure 10)

127(,ILIWKHKHDWHUVWLOOGRHVQRWLJQLWHUHIHUWR

 ³7URXEOHVKRRWLQJ*XLGH´RQSDJH

127(7KH.)$DQG7.)$GRQRWKDYHDURRP

 WHPSHUDWXUHGLVSOD\IHDWXUH

The room temperature display will indicate the

following:

- When the temperature is less than 0 ºF the

display says “LO”.

- When the temperature is more that 99 ºF the

display says “HI”.

- Between 0 °F and 99 °F the display shows

actual temperature.

6WRSSLQJ5HVWDUWLQJ+HDWHU

- To stop the heater, move the power switch to the

“Off” position and unplug the power cord.

- To restart the heater; wait 10 seconds and follow

ignition steps.

Figure 9

Power Switch

Thermostat Knob

Temperature Display

Figure 10

TIP: If the heater does not ignite; move

switch to “Off” position, check steps 1-3

above and then move switch to “On” position.

TIP: If the heater does not ignite, the

thermostat may be set too low. Turn

the control knob to a higher setting until the

heater ignites. If the heater does not ignite;

move switch to “Off” position, check steps 1-3

above and then move switch to “On” position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Remington HH-70T-KFA Troubleshooting Guide Page 9

Comments to this Manuals

Related products and manuals for Space heaters Remington HH-70T-KFA