Remington M12510US User Manual download pdf (Page 9)

113005 www.desatech.com

ENGLISH

ASSEMBLY

Note:

Some models are pre-assembled. Assembly

is not needed on these models.

See Saw Chain Tension Adjustment, pages 8 and 9.

1. Lay chain out ﬂat.

2. Loosen and remove guide bar nut and sprocket

cover.

3. Rotate guide bar retainer so that it is positioned

parallel to guide bar slot (see Figure 4).

4. Install guide bar onto saw body. Assemble cen-

ter slot of guide bar onto guide bar bolt and guide

bar retainer.

Note:

Make sure the head of the

guide bar retainer slides through the guide bar

slot as shown in Figure 4.

WARNING: Cutting edges on chain

are sharp. Use protective gloves when

handling chain.

IMPORTANT: Do not clamp chain saw in

vise during assembly.

Continued

CHAIN SAW NAMES AND

TERMS

Continued

5. Rotate guide bar retainer 90 degrees as shown in

Figure 5.

6. Place chain around drive sprocket, along top groove

of guide bar, and around guide bar nose.

Note:

Make sure cutting edges of chain are facing in right

direction. Position chain so cutting edges on top of

guide bar face guide bar nose (see Figure 6 and

indicator on side cover of saw).

CAUTION: Do not place chain on

saw backwards. If chain is backwards,

saw will vibrate badly and will not cut.

7. Insert tab of sprocket cover into slot on unibody

and rotate sprocket cover onto guide bar bolt un-

til sprocket cover rests against guide bar (see Fig-

ure 7, page 8).

8. Place guide bar nut, removed in step 2, on guide

bar bolt.

IMPORTANT:

Tighten guide bar nut finger tight

only.

Trigger Device that turns saw on and off. Squeezing

trigger turns saw on. Releasing trigger turns saw off.

Trimming (Pruning) Process of cutting limb(s) from

a living tree.

Undercut An upward cut from underside of log or

limb. This is done while in normal cutting position

and cutting with top of guide bar.

Unibody Main body of chain saw.

Figure 4 - Unlocking Guide Bar Retainer

Guide Bar Retainer

Positioned Parallel

to Guide Bar Slot

Figure 5 - Locking Guide Bar Retainer

Guide Bar Retainer

Rotated 90 Degrees

to Guide Bar Slot

Guide Bar

Drive

Sprocket

Drive

Sprocket

Figure 6 - Saw Chain Direction

Cutting Edge

Towards Guide Bar

Nose

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 71 72

Comments to this Manuals

No comments

Remington M12510US User Manual Page 9

Comments to this Manuals

Related products and manuals for Petrol tool Remington M12510US