Remington C-1100i User Manual download pdf

+C e ra m i c

+I o n s

for beautiful,h e a l t hy,

shiny hair

3-in-1 Steam Straightener

with 3X protection

8. Plug in the Protect & Shine

T M

3-in-1 Steam

S t r a i g h t e n e r.

In a few minutes it will be ready

to use.

9. The steam is continuous so it will come out of

the holes as soon as the styler is hot enough.

Please be aware that steam is not necessarily

visible.

10. Keep note of how much water is left in the

reservoir. It usually runs out after being used

for between 35 and 40 minutes.

11. If you run out of water while styling, unplug

the straightener and leave it to cool before

filling up again.

ADDITIONAL INFORMATION

Locking Switch

The locking switch can be used for easy storage

and for use when traveling. To close and lock the

straightener, squeeze the unit and slide the switch

to lock. Make sure the lock is released before you

use the unit.

DUAL VOLTAGE USE

This product contains a special electronic circuit.

This circuit automatically adjusts to worldwide

voltage. When traveling overseas, this product

can be plugged into any voltage outlet without

your having to adjust the product manually in any

way. In some overseas countries, an attachment

plug adapter of the proper configuration for the

power supply receptacle may be required. DO

NOT USE a voltage converter or extension cord

with this product.

OPERATING INSTRUCTIONS

1. With the unit switched off and unplugged,

grip the water reservoir at both sides. Push

in the tabs and pull away from the unit.

2. Twist the wick holder to the right by 90

degrees and pull away from the reservoir.

3. Fill the unit with water, replace the wick holder

and turn 90 degrees to lock again.

Do not remove wick from wick holder as

damage could occur.

4. Snap the reservoir back into place by lining up

the tabs on either side of the unit.

5. Select the plates you wish to use. Release

plates by sliding the thumb tab at the front of

the plate toward the front of the unit and

releasing the plates with your other hand.

6. If you are using the straightening plates, you

may wish to use the detangling comb, which

helps to guide plates over the surface. This

is easily slid on and off the plate.

The detangling comb cannot be used

with the crimping and waving plates.

7. Always heat the unit with the locking

switch in the UNLOCKED position.

NEVER heat the unit when the locking

switch is in the LOCKED position.

IMPORTANT INFORMATION

• B e f o r e using make sure your hair is clean,

d ry, and tangle-fre e .

• For best results use steam. H o w e v e r,

the product can be used without

steam if you pre f e r.

• DO NOT get too close to scalp.

• Hold unit only by the handle, as other

a r eas get hot when in use.

• Use only water in the re s e r voir (except

when cleaning).

• It is important to regularly clean the unit

to prevent any build-up in the water

re s e r voir

• DO NOT use an abrasive cleaning fluid or

material to clean the coated plates, as

damage will occur. Instead, use warm

water and a soft cloth.

• DO NOT scratch the surface of the plates,

as this will deteriorate the effectiveness

of the non-stick c o a t i n g .

STRAIGHTENING YOUR HAIR

1. Take one section of hair approximately 2" wide,

and smooth it out with a comb.

2. Place hair section between the hot plates and

clamp down firmly on the handles. You will

achieve professional results if you work from the

scalp to the ends of the hair.

3. Hold the unit in position for a few seconds

depending on type of hair (5 seconds for

fine hair and up to 8 seconds for medium to

coarse hair).

4. To remove hair from the unit, simply release

pressure on the handles and allow hair to

gently slip out from the straightening plates.

5. The straightening process requires some

overlapping: match the outermost ridge of your

hair with the ridge at the end of the plates.

Close the straightener around the hair and hold

in position again for 5 to 8 seconds.

6. Repeat the process until you have achieved the

look you desire. With a little experimentation

you can attain a hairstyle that is completely your

own.

C-1100i

USER MAINTENANCE

INSTRUCTIONS

To clean the plate surface, make sure the unit

is cool and unplugged before detaching the

plates. Wipe the coated plates with a damp

cloth. No other maintenance is re q u i re d .

To prevent a build-up of hard water limescale

in the water re s e rv o i r, add 3-4 drops of

vinegar to the water re s e rv o i r, top up to

the fill line with water and plug in the

Protect & Shine™ 3-in-1 Steam

S t r a i g h t e n e r. Close the unit to allow it to

steam for around 5 minutes then unplug it

and rinse out the water re s e rv o i r.

STORAGE

When not in use, unplug the unit. Allow it

to cool, empty tank and store out of

reach of children in a safe, dry location.

Never wrap the cord around the appliance

since this will cause the cord to wear

prematurely and break. Handle cord

carefully, and avoid jerking, twisting or

straining it especially at plug connections.

PROT E C T &SH I N E

1 2

Summary of Contents

Page 1 - PROT E C T &SH I N E

+C e ra m i c+I o n sfor beautiful,h e a l t hy,shiny hair3-in-1 Steam Straightener with 3X protection8. Plug in the Protect & ShineT M3-in-1 Ste

Page 2 - I N S T R U C T I O N S

Full Two-Year WarrantyRemington®Products Company, L.L.C.warrantsthis product against any defects that are due tofaulty material or workmanship for a t

Comments to this Manuals

No comments

Remington C-1100i User Manual

Browse online or download User Manual for Hair straighteners Remington C-1100i. Remington C-1100i User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hair straighteners Remington C-1100i