Remington RM2560 Operator's Manual download pdf (Page 6)

ASSEMBLY

INSTALLING THE CUTTING HEAD SHIELD

1. Remove the wing nut and washer from the cutting head shield.

2. Insert the short tab (the one without a hole) on the mount

bracket into the slot on the cutting head shield (Fig. 1).

3. Rotate the cutting head shield until the bolt on the cutting head

shield protrudes through the hole on the mount bracket (Fig. 1).

4. Place the washer onto the bolt (Fig. 2).

5. Screw the wing nut onto the bolt until the cutting head shield is

firmly in place (Fig. 2).

WARNING:

To prevent serious personal injury, never

operate the unit without the cutting head shield in place.

Fig. 3

Bolt

Shaft Grip

Minimum 6 in.

(15.24 cm)

Washer

Handle

Tighten

Wing Nut

INSTALLING AND ADJUSTING THE HANDLE

Installing the Handle

1. Push the handle down onto the shaft housing (Fig. 3). The hex

bolt hole in the handle should be to the left.

2. Insert the bolt into the hex bolt hole and push it through (Fig. 3).

Place the washer onto the bolt. Screw the wing nut onto the

bolt, but do not tighten the wing nut completely .

3. While holding the unit in the operating position (Fig. 7), move the

handle to the location that provides the best grip. Place it a

minimum of 6 inches (15.24 cm) from the end of the shaft grip

(Fig. 3).

4. Tighten the wing nut until the handle is secure.

Adjusting the Handle

If the handle requires adjustment:

1. Loosen the wing nut (Fig. 3).

2. While holding the unit in the operating position (Fig. 7), move the

handle to the location that provides the best grip. Place it a

minimum of 6 inches (15.24 cm) from the end of the shaft grip

(Fig. 3).

3. Tighten the wing nut until the handle is secure.

Fig. 1

Mount Bracket

Cutting Head

Shield

Fig. 2

Washer

Bolt

Slot

Wing Nut

Tab

Bolt

Hole

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Comments to this Manuals

No comments

Remington RM2560 Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Grass trimmers Remington RM2560