Remington MB-70 User Manual download pdf (Page 7)

ENGLISH

080694_REM_IFU_PG410_22L.indd 5080694_REM_IFU_PG410_22L.indd 5 05.11.2008 13:56:09 Uhr05.11.2008 13:56:09 Uhr

TO REPLACE THE FOIL

Remove shaving head assembly by pressing the buttons on both sides of the shaver.

(DIAGRAM A)

Insert ﬁngernail between side of screen and head assembly. Pull away from notches.

(DIAGRAM C)

To reassemble, slide the foil into the shaving head and click into position. Only hold foil

by plastic frame to prevent damage. (DIAGRAM D)

TO REPLACE THE CUTTER

Remove head assembly as shown. (DIAGRAM A)

Grasp cutter between thumb and foreﬁnger and pull upward. (DIAGRAM E)

Snap new cutter into top of oscillator tip.

Note: Do not press on the cutter ends as this may cause damage. (DIAGRAM E)

Replacement cutter & foil available: SP410

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE,

OR INJURY TO PERSONS:

An appliance should never be left unattended when plugged into a power outlet.

WARNING: Detach the hand-held part from the supply cord before cleaning it in water.

WARNING: The parts that have to be ﬁxed must be installed so they cannot fall into water.

Keep the power plug and cord away from heated surfaces.

Make sure the power plug and cord do not get wet.

Do not plug or unplug the product with wet hands.

Do not use the product with a damaged cord. A replacement can be obtained via our

International Service Centres.

Charge, use and store the product at a temperature between 15°C and 35°C

Always unplug from the mains when cleaning.

Only use the parts supplied with the appliance.

Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge can

give cause to hazards. Persons responsible for their safety should give explicit instructions

or supervise the use of the appliance.

1 2 3 4 5 6 7 8 9

No comments

Remington MB-70 User Manual Page 7