Remington RM3017HP Specifications download pdf (Page 10)

MAINTENANCE AND CLEANING

SERViCiNG POLE TRIMMER

The Pole Trimmer is a double-insulated tool

and contains some parts that can only be re-

placed with original parts by an Authorized

Service Center. For service, please call the

Customer Support Department to obtain

a list of authorized service dealers

near you. Call 1-866-206-2707 (in Canada,

call 1-877-696-5533).

,'LEANING TRIMMER

_1_ WARNING: Disconnect Pole

Trimmerfrom power suppiybefore

cleaning or servicing. Severe in=

juryor death could occur from fire,

electrical shock, or body contact

with moving cutter blades.

4Bk WARNING: When cleaning

Pole Trimmer:

• Do not submerse PoleTrimmer

in any liquids

• Do not use products that con=

tain Ammonia, Chlorine, or

abrasives

• Do not usechlorinated cleaning

solvents, Carbon Tetrachloride,

Kerosene, or Gasoline.

Use a soft cloth dampened with a mild soap

and water mixture to wipe Pole Trimmer

pole, housing, and cutter blades clean. Do

not spray or pour water directly onto Pole

Trimmer.

Once the Pole Trimmer is cleaned, apply

a light coat of oil to the cutter blades to

prevent rust and provide lubrication (motor

oil is preferred).

BLADE REPLACEMENT

A

WARNING:To prevent serious

personal injury, wear gloves when

removing and installing the cut-

ter blades. Do not place fingers

or hands between blades where

they could get cut.

l.

2.

Unplug pole trimmer frompower supply.

Place pole trimmer upside down on

workbench and remove the four (4)

bottom cover screws. Lift bottom cover

off (see Figure 17).

Cover Screw

Bottom Cover

Figure 17 - Removing Bottom Cover from

Trimmer Head

3. Remove M5 locknut and washer from

cam (see Figure 18).

4. Align cam and cutter blade assemby.

Remove cam. (see Figure 18).

M5 Locknut

Cutter Blade

Assembly

Figure 18 - Removing Cam

. Remove screw that holds down cutter

blade assembly (see Figure 19). IM-

PORTANT" Be sure not to loose the

8-32 locknut that secures this screw.

.....Screw

z Cutter Blade

Assembly

Cam Flange

Figure 19

Assembly

8=32Locknut

@ ooo-

- Removing Cutter Blade

6. Remove and dispose of cutter blade

assembly.

7. Attach new cutter blade assembly to

power head with screw and locknut

removed in step 5.

8. Align cutter blade assembly so that

the cam will fit properly into the oval-

shaped lobes of the cutter blade assem-

bly (see Figure 19). IMPORTAN7? The

large diameter flange of the cam must

face upward away from the power head.

The small diameter flange of the cam

must line up with and sit directly on top

of the cam flange.

9. Replace washer and locknut removed

in step 3. Tighten securely.

10. Replace the bottom cover and se-

cure with the 4 bottom cover screws

removed in step 2 (see Figure 17).

Tighten screws securely.

_, WARNING: All components

must be installed and securely

fastened before plugging pole trim-

met into power supply. Failure to

do so may cause product damage

or serious personal injury.

Note: If binding occurs after reassembly,

repeat all of the previous steps making sure

that cam aligns properly with cutter blade

assembly.

11

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Comments to this Manuals

No comments