Remington HEDGE WIZARD 110946-01 Owner's Manual download pdf (Page 9)

9

110939

OWNER’S MANUAL

For more information, visit www.desatech.com

REPAIR SERVICE

Note:

Only use original replacement parts.

This will protect your warranty coverage for

parts replaced under warranty.

Each Authorized Service Center is indepen-

dently owned and operated.

For additional Service Center or warranty

information, call 1-800-858-8501 or visit

our Technical Service web site at

www.desatech.com.

WARRANTY SERVICE

If product requires warranty service, return it

to nearest Authorized Service Center. You

must show proof of purchase. If faulty mate-

rials or workmanship caused damage, we

will repair or replace product without charge.

Note:

Normal wear, misuse, abuse, neglect,

or accidental damage is not covered under

warranty.

NON-WARRANTY SERVICE

If product requires service, return it to near-

est Authorized Service Center. Repairs will

be billed to you at regular repair list prices.

TECHNICAL

SERVICE

You may have further questions about as-

sembling, operating, or maintaining this

product. If so, you can visit our Technical

Service web site at www.desatech.com

or contact our Technical Service Depart-

ment at 1-800-858-8501 (English Only).

You may also write to:

DESA Specialty Products™

ATTN: Technical Service Specialty Products

P.O. Box 90004

Bowling Green, KY 42102-9004

When contacting DESA Specialty Prod-

ucts™, have ready

•Your Name

•Your Address

•Your Phone Number

• Model Number of Product

• Date of Purchase (Include copy of receipt

for written requests).

REPLACEMENT

PARTS AND

ACCESSORIES

For original replacement parts and accesso-

ries, contact your nearest Authorized Dealer

or Authorized Service Center for this prod-

uct. If they can not supply the part or acces-

sory, contact your nearest Parts Central listed

on page 12. Each Authorized Dealer, Au-

thorized Service Center, and Parts Central is

independently owned and operated.

See pages 10 and 11 for an Illustrated Parts List.

If you need additional referral information,

contact our Technical Service Department

(see Technical Service).

In Canada call 1-800-561-3372 for parts

information.

Note:

If binding occurs after reassembly,

repeat all of the previous steps making sure

that cam aligns properly with cutter blade

assembly.

WARNING: All components

must be installed and securely fas-

tened before plugging pole trim-

mer into power supply. Failure to

do so may cause product damage

or serious personal injury.

5. Remove screw that holds down cutter

blade assembly (see Figure 19).

SERVICING POLE

TRIMMER

(Continued)

6. Lift and twist the cutter blade assem-

bly to disengage from cam, being care-

ful not to rotate cam.

Note:

The cam is

not secured by any fasteners. If cam lifts

off with cutter blade assembly, replace

cam with large diameter flange facing

downward toward trimmer power head

before replacing cutter blade assembly.

7. Remove the same two 5/16" nuts from

the new cutter blade. Align cutter blade

slots and fit onto cam.

8. Replace screw from Step 5. Tighten se-

curely.

9. Replace the cam cover and secure the

two 5/16" nuts from Step 6.

Note:

When properly aligned, cam cover fits

into recess of motor housing.

10. Replace the bottom cover and secure

with the 4 bottom cover screws. Tighten

screws securely.

Figure 19 - Removing Cutter Blade

Assembly

Screw

Cutter Blade

Assembly

Cam

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments