Remington HEDGE WIZARD 110946-01 Owner's Manual download pdf (Page 8)

8

110939

ELECTRIC POLE TRIMMER

®

For more information, visit www.desatech.com

TROUBLESHOOTING

OBSERVED FAULT

Motor does not run when you squeeze trig-

ger lever

Motor runs, but cutting blades do not move

Pole Trimmer smokes during operation

POSSIBLE CAUSE

1. Trigger lock button not pressed to release

trigger lever

2. Extension cord connection is loose

3. Household circuit breaker is tripped or

open line fuse

4. Bad motor brushes

5. Open wiring on Pole Trimmer

Pole Trimmer damaged. Do not use Pole

Trimmer

Pole Trimmer damaged. Do not use Pole

Trimmer

REMEDY

1. Push lock button forward and squeeze

trigger lever (see Starting the Pole Trim-

mer, page 5)

2. Check cord connections

3. Check circuit breaker or line fuse

4. Call for Technical Service

5. Call for Technical Service

Call for Technical Service

Call for Technical Service

Note:

For additional help, visit our

technical service web site at

www.desatech.com.

WARNING: Unplug Pole Trimmer from power source before servicing.

Severe injury or death could occur from fire, electrical shock, or body

contact with moving blades.

SERVICING POLE

TRIMMER

The Pole Trimmer is a double-insulated tool

and contains some parts that can only be

replaced with original parts by an Autho-

rized Service Center. Visit our Technical

Service web site at www.desatech.com

or contact our Technical Service Depart-

ment at 1-800-858-8501 (English Only) for

the nearest Authorized Service Center.

The parts listed on pages 10 and 11 are

considered to be user replaceable. See Re-

placement Parts and Accessories, page 9,

for information on ordering these parts.

1. Unplug pole trimmer from power supply.

2. Place pole trimmer upside down on

workbench and remove the four (4)

bottom cover screws. Lift bottom cover

off (see Figure 17).

WARNING: To prevent seri-

ous personal injury, wear gloves

when removing and installing the

cutter blades. Do not place fin-

gers or hands between blades

where they could get cut.

BLADE REPLACEMENT

3. Remove the two 5/16" nuts closest to

the power head and lift off cam cover

(see Figure 18). These parts will be in-

cluded with the new cutter blade and

will not be needed.

4. Rotate cam so that cam and cutter blade

assembly slot are aligned (see Figure 18).

Cover Screw

Bottom Cover

Figure 17 - Removing Bottom Cover from

Trimmer Head

5/16" Nut

Washer

Cam Cover

Figure 18 - Removing Cam Cover

Cam

Cutter Blade Assembly

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments