Remington HEDGE WIZARD 110946-01 Owner's Manual download pdf (Page 7)

7

110939

OWNER’S MANUAL

For more information, visit www.desatech.com

TRIMMING A HEDGE

Use the Pole Trimmer properly. Always

wear eye protection, rubber gloves, and

substantial foot wear while using the Pole

Trimmer. Always maintain proper footing

and balance and never overreach when us-

ing Pole Trimmer. Before starting the Pole

Trimmer, hold the unit with both hands on

the grip areas. Make sure that the cutter

blade is not touching anything.

Always keep the extension cord behind the

Pole Trimmer when in use. Do not drape the

cord over the hedge where it may be cut by

the blades.

Use smooth steady sweeping motions to

trim new growth. Do not try to cut too much

at one time. This can cause the Pole Trim-

mer to slow down or get jammed, reducing

the cutting efficiency.

CLEANING AND

MAINTENANCE

WARNING: Disconnect Pole

Trimmer from power supply be-

fore cleaning or servicing. Severe

injury or death could occur from

fire, electrical shock, or body con-

tact with moving cutter blades.

WARNING: When cleaning

Pole Trimmer:

• Do not submerse Pole Trim-

mer in any liquids

• Do not use products that con-

tain Ammonia, Chlorine, or

abrasives

• Do not use chlorinated clean-

ing solvents, Carbon Tetrachlo-

ride, Kerosene, or Gasoline.

Use a soft cloth dampened with a mild soap

and water mixture to wipe Pole Trimmer

pole, housing, and cutter blades clean. Do

not spray or pour water directly onto Pole

Trimmer.

Once the Pole Trimmer is cleaned, apply a

light coat of oil to the cutter blades to pre-

vent rust and provide lubrication (motor oil

is preferred).

Figure 16 - Trimming Hedge

Do not force the Pole Trimmer through

dense growth. A slight back and forth saw-

ing action may ease the cutting of larger,

more dense growth. If the Pole Trimmer

begins to slow down, reduce the rate of

speed at which you are trying to cut.

If the Pole Trimmer becomes jammed, im-

mediately turn Pole Trimmer off. Discon-

nect Pole Trimmer from the power supply

and remove the jammed debris from the

cutter blades.

Do not try to cut branches larger than

3/4 inch in diameter.

For best results, trim the sides of hedges with

an upward sweeping motion. Trim the hedges

so that the top is slightly narrower than the

bottom. To trim extremely level hedges, use

a string stretched along the length of the

hedge as a guide (see Figure 16).

OPERATING POLE

TRIMMER

Continued

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments