Remington BH1822A Specifications download pdf (Page 8)

www.remingtonpowertools.com

122044-01B8

RECHARGEABLE BATTERY

IMPORTANT CHARGING NOTES

1. After normal usage, your battery pack

should be fully charged in 3 to 9 hours. If

the battery pack is run-down completely,

it may take up to 9 hours to become fully

charged. Your battery pack was sent from

the factory in an uncharged condition. For

best performance charge battery until red

LED turns off. Allow the battery to cool

down 30 minutes before charging after

using the trimmer. NOTE: A hot battery

placed in the charger will not charge.

2. DO NOT charge the battery pack in an

air temperature below 40°F (4,5 °C) or

above 105°F (40,5 °C). This is important

and will prevent serious damage to the

battery pack. Longest life and best per-

formance can be obtained if battery pack

is charged when air temperature is about

75°F (24°C).

3. While charging, the charger may hum

and become warm to touch. This is a

normal condition and does not indicate a

problem.

4. If battery pack does not charge properly

•Checkcurrentatreceptaclebyplugging

in a lamp or other appliance.

•Checktoseeifreceptacleisconnected

to a light switch which turns power off

when you turn out the lights.

•Movechargerandbatterypacktoasur-

rounding air temperature of 40°F (4,5°C)

to 105°F (40,5 °C)

•If the receptacle and temperature are

OK, and you do not get proper charging

contact DESA Power Tools.

5. The battery pack should be recharged

whenitfailstoproducesufcientpower

on jobs which were easily done previously.

DONOTCONTINUEusingproductwith

its battery pack in a depleted condition.

6. To prolong battery life, avoid leaving the

battery pack on charger for extended pe-

riods of time (over 30 days without use).

Although overcharging is not a safety

concern,itcansignicantlyreduceoverall

battery life.

7. The battery pack will reach optimum per-

formance after being cycled 5 times during

normal usage. There is no need to run the

batteries down completely before recharg-

ing. Normal usage is the best method of

discharging and recharging the batteries.

TRIMMER OPERATION

STARTING THE HEDGE TRIMMER

As a safety feature, this trimmer requires the

trigger lockout button to be pressed prior to

squeezing the trigger (see Figure 4).

WARNING

Do not modify this trimmer to

bypass the trigger lockout but-

ton. This feature is designed to

prevent unintentional starting of

the trimmer.

BASIC TRIMMER OPERATION

This tool is designed to trim and shape hedges

and shrubs with ease. Follow the steps below

to start and stop the trimmer.

1. Place fully charged battery in trimmer (see

Figure 5).

2. Hold the front handle with one hand (see

Figure 6, page 9).

Figure 4 - Front and Rear Trigger

Switches

Figure 5 - Placing Battery in Trimmer

Trigger Lockout Button

Trigger Switch

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments