Remington CLD3516AWB Owner's Manual download pdf (Page 14)

www.desatech.com

2" to 4"

(5 a 10 cm)

2nd Cut - Pruning Cut (to avoid pinching)

1st Cut - Pruning Undercut (to avoid

splintering)

3rd Cut - Stub Undercut (to avoid

splintering)

(15 cm)

4th Cut - Final Stub Cut

OPERATING CHAIN SAW

TRIMMING A TREE (Pruning)

WARNING: Do not cut limbs higher

than your shoulders.

CAUTION: Seek professional help if

facing conditions beyond your ability.

WARNING: Do not operate chain

saw while

• in a tree

• on a ladder or any other unstable sur-

face

• in any awkward position

You may lose control of saw causing

severe injury.

Trimming a tree is the process of cutting limbs from

a living tree. Make sure your footing is ﬁrm. Keep

feet apart. Divide your weight evenly on both feet.

Follow directions below to trim a tree.

1. Make ﬁrst cut six inches from tree trunk on

underside of limb. Use top of guide bar to make

this cut. Cut 1/3 through diameter of limb (see

Figure 13).

2. Move two to four inches farther out on limb.

Make second cut from above limb. Continue cut

until you cut limb off.

3. Make third cut as close to tree trunk as possible

on underside of limb stub. Use top of guide bar to

make this cut. Cut 1/3 through diameter of stub.

4. Make fourth cut directly above third cut. Cut down

to meet third cut. This will remove limb stub.

Figure 13 - Cutting A Limb

WARNING: Avoid kickback. Kickback

can result in severe injury or death. See

Kickback, pages 4 and 5, to avoid risk

of kickback.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Comments to this Manuals

No comments

Remington CLD3516AWB Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Power chainsaws Remington CLD3516AWB