Remington IPL4000 Troubleshooting Guide download pdf (Page 14)

Getting Acquainted With i-Light

Treat desired area(s) with the i-Light device –

Single Flash Mode

1. Place the i-Light hand piece against your skin so the Flash

Window is flush with the skin surface (fig. 8).

2. Ensure the Skin Contact Sensor is fully engaged and the Bulb

Status Indicator Display is illuminated.

3. Press the Flash Button to activate the device (fig. 9).

4. Move the hand piece to a new treatment area and repeat

steps 1-3 (fig. 10).

Treat desired area(s) with the i-Light device –

Multi Flash Mode

1. Place the i-Light hand piece against your skin so the Flash

Window is flush with the skin surface (fig. 8).

2. Ensure the Skin Contact Sensor is fully engaged and the Bulb

Status Indicator Display is illuminated.

3. Press AND HOLD the Flash Button down to activate the

device (fig. 9).

4. Immediately after the device has flashed, slide the hand piece

to a new location. After a short delay (approximately

2 seconds) the device will flash again (fig. 10).

NOTE: ■ During Multi-Flash Mode, the Skin Contact Sensor

AND the Flash Button must remain fully depressed.

If either becomes disengaged, the device will not

operate. To resume treatment, repeat steps 1-4.

■ During Multi-Flash Mode, the Bulb Status Indicator

Display will remain illuminated while the Skin

Contact Sensor and Flash Button are engaged.

]

090597_REM_IFU_IPL5000_7L GB13090597_REM_IFU_IPL5000_7L GB13 23.07.09 22:0323.07.09 22:03

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 157 158

No comments

Remington IPL4000 Troubleshooting Guide Page 14