Remington 18A-212B783 Owner's Manual download pdf (Page 16)

If the overload protection switch pops out shortly after resetting:

Release the motor/blade control handle and do NOT restart 1.

the mower for at least 15 minutes to allow the electric

motor extra time to cool.

Press the overload protection switch inward to reset.2.

Restart unit.3.

NOTE: If the overload protection switch pops out

repeatedly during operation or will not remain in when

attempting to reset, you may need to raise the cutting

height to reduce the strain on the motor or recharge the

battery. If the overload protection switch will not remain in,

contact an authorized service center to arrange for repair.

Replacing Trail Shield

WARNING: Never operate mower unless the trail

shield is in place and working. Never operate mower

with damaged safety devices. Failure to do so, can

result in personal injury.

The trail shield is subject to wear and damage which could

expose moving parts or allow objects to be thrown. For safety

protection, frequently check the trail shield and replace

immediately with original equipment manufacturer’s (OEM) part

only, listed in this manual.

Using a 10mm wrench, hold one lock nut in place while the 1.

opposite lock nut is loosened and removed. See Fig. 6-3.

Remove the rod running through the trail shield and 2.

replace with new shield in the opposite order and manner

of removal.

Figure 6-3

Battery Care

IMPORTANT: Replace with only the identical batteries provided

with this mower. The batteries should only be replaced by an

authorized service dealer.

WARNING: Due to a potential shock hazard, DO

NOT attempt to remove the motor/battery shroud.

There are no user serviceable parts inside. Contact

your nearest Authorized Service Center if repairs are

needed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Remington 18A-212B783 Owner's Manual Page 16