SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
Starting with the longest
), cut from the back of the neck to
the crown. Hold the guide comb flat against the head and slowly move the clipper through
the hair, as shown. (PICTURE 1)
Use the same procedure from the lower side to the upper side of the head, as illustrated.
Then cut the hair against the direction in which it grows and level with the sides.
(PICTURE 3)
To give a “flat top” look, the hair on top of the head must be cut over the top of a flat
comb.
Use a closer guide comb to taper the hair down to the neckline as desired.
STEP 5 – The finishing touches – PICTURE 5
Use the clipper without an attachment comb for close trimming around the base and sides
of the neck. Use the ear comb guides to get a clean line around each ear. For the required
ear comb guide, angle the clipper and lightly stroke around each ear to the back of the
neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin and
then work downwards.
24mm-42
INSTRUCTIONS FOR THE STUBBLE GUIDE COMB (Only for HC5550 & HC5750)
The 1.5mm guide comb is designed to create the perfect 3-day beard look.
Place the flat top of the trimmer comb against the skin.
Slowly slide the trimmer through the beard. Repeat from different direction as necessary.
If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull
off the comb and brush/rinse off.
AUTO BOOST SYSTEM (Only for HC5750)
There are 3 settings for the Auto Boost system: Off, Auto and Boost.
If the clipper is set to Auto it will run at regular power under low load conditions.
When more power is needed, the clipper with automatically sense and provide maximum Boost.
If the clipper is set to Boost, it will run at maximum power at all times.
DUAL BOOST SYSTEM (Only for HC5550)
There are 3 settings for the Dual Boost system: Off, On, Boost.
If the clipper is set to On, it will run at regular power.
If the clipper is set to Boost, it will provide maximum power.
Always work from the back of the head.
Use the longer length comb attachment and set it to 24mm or 27mm
then cut hair on top of the head against the direction in which the hair normally grows.
STEP 4 – Top of the head – PICTURE 4
For longer hair on top, use the longer length comb attachment (24-42mm) to achieve desired style.
HAIR THINNER MECHANISM
Simply adjust the hair thinner mechanism by sliding the button at the top of the hair clipper.
Blending different length areas. Select the proper length guard to blend. Slide out the Texture/Thin out feature.
Textured cut – Slide out the texture/thin out feature with the guard in place to give an all over textured cut.
(2 pages)
(156 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals