Remington D5800 Instruction for Use download pdf (Page 5)

ENGLISH

GBDNLFEIDKSFINPSKCZPL

HUN

RUTRROGRSLAE

HR/

SRB

Always ensure the voltage to be used corresponds to the voltage stated on the unit.

Do not direct the airﬂow towards the eyes or other sensitive areas.

Do not use any attachments with this hairdryer, other than those supplied by

Remington

Avoid allowing any part of the hairdryer to contact the face, neck or scalp.

This appliance is not intended for commercial or salon use.

If the supply cord of this unit becomes damaged, discontinue use immediately and

return the appliance to your nearest authorised Remington

service dealer for repair or

replacement in order to avoid a hazard.

Special tools are required for any examination, adjustment or repair. Unqualiﬁed repair

work could lead to hazardous conditions for the user.

We do not accept responsibility for damage to the product, persons or other item(s),

caused by misuse, abuse or non-compliance with these instructions.

Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge

can give cause to hazards. Persons responsible for their safety should give explicit

instructions or supervise the use of the appliance.

WIRING INSTRUCTIONS UK PLUGS ONLY

This product is ﬁtted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be

disconnected and an appropriate plug ﬁtted as detailed below. If it is necessary to replace

the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult

a qualiﬁed electrician.

The wires in the mains lead are coloured in accordance with following code:

BLUE - NEUTRAL

BROWN - LIVE

As the colours of the wires in the mains lead of this appliance may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows:

- The wire which is coloured BLUE must be connected to the terminal which is marked ‘N’

or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked

‘L’ or coloured RED. Never connect either of the wires to the big EARTH terminal marked

‘E’ or coloured GREEN or GREEN AND YELLOW.

110444_REM_IFU_D5800_21L.indd GB_3 24.06.11 16:33

1 2 3 4 5 6 7 8 9 10 ... 87 88

No comments

Remington D5800 Instruction for Use Page 5