Remington HC5030 User Manual download pdf (Page 4)

ENGLISH

HOW TO USE

Before starting the cut

Inspect the clipper making sure that it is free from hair and dirt.

To attach a comb

Hold the comb with its teeth upward

Slide it onto and along the clipper blade until the front of the comb ﬁrmly sits against the

clipper blade.

To remove the comb

Holding the clipper with the blades facing away from you, ﬁrmly push the comb upward

and away from the blades.

Comb Attachments Hair Lenghth

Each comb attachment is marked accordingly on its outside middle surface (3mm, 6mm,

12mm, 15mm, 18mm, 25mm, and 30mm). 0.5mm length is achieved without any combs

INSTRUCTIONS FOR HAIR CUTTING

STEP 1 – Nape of the neck – PICTURE 1

Use 3mm or 6mm guide comb.

Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the

head at the base of the neck.

Slowly lift the clipper, working upwards and outwards through the hair, trimming just a

little at a time.

STEP 2 – Back of the head – PICTURE 2

With the 12mm, 15mm or 18mm guide comb attached, cut the hair at the back of the head.

STEP 3 – Side of the head – PICTURE 3

With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer

9mm or 12mm guide comb and continue to cut to the top of the head.

STEP 4 – Top of the head – PICTURE 4

With the 18mm, 25mm, 30mm guide comb attached, cut hair on top of the head against

the direction in which the hair normally grows.

For longer hair on top, use without a guide comb. Lift the hair on top of the head with a

small hand comb. Cut over the hand comb with the hair lifted or hold the hair between the

ﬁngers to lift it and cut it to the desired length.

Always work from the back of the head.

100591_REM_IFU_HC5030_ INT_ 21L.indd GB2100591_REM_IFU_HC5030_ INT_ 21L.indd GB2 11.08.10 21:2911.08.10 21:29

1 2 3 4 5 6 7 8 9 ... 109 110

No comments

Remington HC5030 User Manual Page 4