5
ENGLISH
adjust to the desired cutting length following the steps below.
•Withthelonglengthcombinstalledontotheproductandthecorrespondingcomb
switchselected(A)theadjustmentcanbegin.Thelengthcannowbeincreasedor
decreased in 0.5mm increments. Also ensure that the locked button is in the unlocked
position.
•Fortheshortlengthcombthereare2combswitchsettings,Bwillincreaseanddecrease
the cutting length in 0.5mm increments and setting C will adjust the length in 0.1mm
increments.
Note: Ifaredwarninglightisvisiblethroughthecombwheninstalled,thisisindication
that the comb selection switch is on the wrong setting.
• Pressandholdthearrowuptoincreasethecuttinglengthanddowntodecreaseit.The
comb will move to reach each setting, the lengths will change as you hold the up/down
arrow, and the setting number will appear on the digital display.
• Selectthedesiredboostlevelbypressingtheboostbuttonwiththelockinthe
unlocked position. The display will indicate the level.
• Oncethedesiredlengthandboostlevelarereached,lockthesystemusingthelock
switch. The display should show a closed lock, and the current length setting and boost
level. Proceed to use the clipper
• Note: Adjustments to length and boost can be done anytime the lock switch is set to
unlock. Setting can be done with the main motor o, if the power button is pressed a
second time. To turn the main motor back on the power button needs to be pressed
again.
• Pressandholdthebatteryicontodisplaytheremainingbatterytimeinminutesonthe
digital display. This can be used whilst the appliance is locked.
, SWITCHING BETWEEN UNITS OF LENGTH (mm, #)
Holdthepowerbuttonfor3seconds,thedisplaywillshowthechangebetweenmmand#,at
this time release the power button. The setting has been changed.
Note:Iftheusercontinuestoholdthepowerbuttonfor8seconds,thesystemwillenterreset
mode
A CAUTION
Once the digital display changes from mm to grade number, release the power button to avoid
an inadvertent restart.
NOTE: The comb must be attached to the appliance in order to use the hair length selector. To
achieve 0.4mm the comb must be removed.
, Touch Lock
•Onceyourdesiredlengthandmotorspeedisset,lockthedevicebyslidingtheswitch
into the lock position.
•Theappliancewillnotcutifthelockswitchisintheunlockposition.
, Before Starting The Cut
• Inspecttheclippermakingsurethatitisfreefromhairanddirt.
• Seatthepersonsothattheirheadisapproximatelyatyoureyelevel.
• Beforecutting,alwayscombthehairsoitistanglefreeanddry.
Comments to this Manuals