Remington BS1812A Owner's Manual download pdf (Page 8)

8

TRIMMER ASSEMBLY

ASSEMBLING TRIMMER/

EDGER

Figure 4 - Placing cutting guard over cut-

ting head

Figure 5 - Slide cutting guard forward

Attaching Cutting Guard

and Edging Wheel

1. Remove ﬁ ve mounting screws taped to

underside of cutting guard.

2. Place cutting guard over spool housing at

a slight angle. Push guard back depressing

tabs toward front of cutting guard. (See

ﬁ gure 4). Drop back of cutting guard into

place.

3. Slide cutting guard forward. (See ﬁ gure

5)

4. Insert mounting screw into hole near-

est tabs in cutting guard. Tighten screw

ﬁ rmly. (See Figure 6)

5. Insert two mounting screws into holes at

back of cutting guard. (See Figure 7)

6. Place edging wheel over remaining two

screw holes at front of cutting guard. At-

tach edging wheel using two mounting

screws. (See Figures 8 and 9)

FPO

Figure 7 - Insert two mounting screws

FPO

Figure 6 - Insert mounting screw

Figure 8 - Placing edging wheel over

screw holes

Figure 9 - Attaching edging wheel

Figure 10 - Removing knob and bolt from

handle

Figure 11 - Placing handle onto shaft

Figure 12 - Inserting bolt into handle

Figure 13 - Tighten the knob

1. Remove the knob and bolt from front

handle (see Figure 10).

2. Place the handle on the trimmer/edger

shaft between the rear handle and shaft

collar. Snap handle onto shaft (see Figure

11).

3. Insert bolt back into the front handle (see

Figure 12).

3. Adjust handle to the most comfortable po-

sition and tighten the knob ﬁ rmly. Do not

overtighten the knob. (See Figure 13).

Do not operate trimmer/edger

without guard or handle in

place.

WARNING:

ATTACHING ADJUSTABLE

FRONT HANDLE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments