Remington 25A-26J7783 Owner's Manual download pdf (Page 14)

Troublesho oting

Problem Cause Remedy

Engine Fails to start 1. Control lever disengaged.

2. Spark plug boot disconnected.

3. Fuel tank empty or stale fuel.

4. Engine not primed (if equipped with primer).

5. Faulty spark plug.

6. Blocked fuel line.

7. Engine flooded.

8. Fuel valve (if equipped) closed.

9. Engine not choked (if equipped with choke).

1. Engage control lever.

2. Connect wire to spark boot.

3. Fill tank with clean, fresh gasoline.

4. Prime engine as instructed in the Operation

section.

5. Clean, adjust gap, or replace.

6. Clean fuel line.

7. Wait a few minutes to restart, but do not

prime.

8. Open fuel valve. See engine manual.

9. Choke engine. See engine manual.

Engine runs erratic 1. Spark plug boot loose.

2. Blocked fuel line or stale fuel.

3. Vent in gas cap plugged.

4. Water or dirt in fuel system.

5. Dirty air cleaner.

6. Unit running with CHOKE (if equipped)

applied.

1. Connect and tighten spark plug boot.

2. Clean fuel line; fill tank with clean, fresh

gasoline.

3. Clear vent.

4. Drain fuel tank. Refill with fresh fuel.

5. Refer to engine manual.

6. Push CHOKE knob in.

Engine overheats 1. Engine oil level low.

2. Air flow restricted.

1. Fill crankcase with proper oil.

2. Clean area around and on top of engine.

Occasional skips

(hesitates) at

high speed

1. Spark plug gap too close. 1. Adjust gap to .030”.

Idles poorly 1. Spark plug fouled, faulty, or gap too wide.

2. Dirty air cleaner.

1. Reset gap to .030” or replace spark plug.

2. Refer to engine manual.

Excessive Vibration 1. Spindle wing nuts loose.

2. Spindle damaged.

1. Tighten wing nuts.

2. See an authorized service dealer.

Poor Trimming Performance 1. Trimmer line too short or worn.

2. Worn or damaged spindle belt.

1. Replace trimmer line.

2. Replace spindle belt.

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Remington 25A-26J7783 Owner's Manual Page 14

Comments to this Manuals