4
STEP 5 – The fi nishing touches – PICTURE 5
Use the clipper without an attachment comb for close trimming around the base and sides
of the neck. Use the ear comb guides to get a clean line around each ear. For the required
ear comb guide, angle the clipper and lightly stroke around each ear to the back of the
neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the skin and
then work downwards.
SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
Starting with the longest guide comb attached (25mm), cut from the back of the neck to
the crown. Hold the guide comb fl at against the head and slowly move the clipper through
the hair, as shown. (PICTURE 1)
Use the same procedure from the lower side to the upper side of the head, as illustrated.
Then cut the hair against the direction in which it grows and level with the sides.
(PICTURE 3)
To give a “fl at top” look, the hair on top of the head must be cut over the top of a fl at
comb.
Use a closer guide comb to taper the hair down to the neckline as desired.
TAPER L EVER
This product has a taper lever located a the left side of the clipper near the blades. Adjust
the lever to change the closeness of the cut gradually and also to improve the effectiveness of
the comb attachments. The taper lever also extends the life of the blades because a different
cutting edge is used in each setting.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fi tted with high quality ceramic blades that are premanently lubricated. To
ensure long lasting performance of your clipper, clean the blades and unit regularly. Always
keep the protective cap on the trimmer blade.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fi xed blade with a screwdriver.
Do not remove blade set.
ENGLISH
080162_REM_IFU_HC365_UK.indd 4 28.02.2008 14:00:37
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals