Remington 220H User Manual download pdf (Page 17)

Manufacturer’s Warning

This firearm was manufactured to properly perform with the original parts as designed. It is your duty to make

sure any parts you buy are correctly installed and that neither replacements nor originals are altered or changed.

Your shotgun has many parts that must relate correctly to other parts for safe and accurate operation. Putting a

gun together wrong or with modified parts can result in a damaged gun, or personal injury or death to you or

others. Always let a qualified gunsmith work on your gun or at least, check any work not performed

by a gunsmith. Firearms safety is your primary concern.

THE GUN OWNER MUST ACCEPT FULL

RESPONSIBILITY FOR THE CORRECT REASSEMBLY AND FUNCTIONING OF THE FIREARM AFTER

ANY DISASSEMBLY OR REPLACEMENT OF PARTS.

To Clean and Maintain Your Shotgun

A. Follow procedures for unloading shotgun as described previously.

B. Follow procedures for disassembly of shotgun as described previously.

C. Materials needed to clean this shotgun are: a cleaning rod, cotton bore patches, brass bore brush,

powder solvent (such as Remington BriteBore

™

), a small soft brush and good quality gun oil

(such as Rem

Oil).

WARNING

Lead or lead compounds are known to the State of California to cause cancer, birth defects, reproductive toxicity, and other serious physical

injury. Those who clean firearms should take protective measures to avoid contact or exposure to such chemicals.

D. Using the bore brush with powder solvent, scrub the interior of the barrel and chamber to remove any

powder and lead residue in the bore. Always and lastly, swab the interior of the barrel with a cotton patch

with gun oil to coat and protect the bore and chambers from rust and corrosion.

E. Any powder fouling on the firing wall, barrel, etc. can be easily cleaned with a brush and powder solvent.

F. All external surfaces should be wiped down with a light coat of rust preventative. Avoid using too much

oil as powder, dust or other foreign material may get trapped in the oil. This could lead to congealed

deposits which may interfere with the safe and reliable operation of this shotgun.

USE CAUTION while using solvents in gun bore cleaning. Prolonged or excess contact with

solvents can damage the gun’s bluing and finish. Be sure to wipe away all excess solvent and then

lubricate with oil.

A gun should be cleaned after firing. In addition, exter

nal par

ts should be wiped with an oiled cloth

after handling. A light oil is or

dinarily all that is necessary in cleaning if the gun has not been fired or fired

very little. If a gun is used frequently, it must be cleaned after each firing and regularly serviced by a

professional gunsmith. If the gun has been stored, remove all excess oil and/or grease before firing.

Always check to be sure that no cleaning patch or other obstruction remains in the bore or chambers

before firing.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Remington 220H User Manual Page 17