Remington 491 User Manual download pdf (Page 19)

099494

6. Remove piston assembly from piston sleeve (see Figure 4).

7. Tilt rear of base plate down. Guide will slide out.

REMOVING RUBBER PAD

1. Loosen screw on back of rubber pad with 5mm Allen wrench.

2. Detach rubber pad from top of tool first, then pull entire rubber pad from tool.

REMOVING ROCK ARM

Rock arm assembly is located on rubber pad.

1. Push out rock arm pin (see Figure 6).

2. Remove rock arm and spring from rubber pad.

Figure 4 - Removing Piston From Piston Sleeve

Figure 5 - Removing Rubber Pad

Rock Arm

Spring

Figure 6 - Removing Rock Arm

Piston

Piston Sleeve

Rubber Pad

Rock

Arm Pin

Rubber Pad

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Remington 491 User Manual Page 19